Engineering Laboratory (Lab) Report Department of Engineering Faculty of Engineering and Science‚ University Tunku Abdul Rahman (UTAR) 1. Introduction Laboratory (Lab) reports are the most frequent document written by engineering student. These reports can contribute a significant amount of marks and yet little time or attention is devoted in understanding on how to write them well. The aim of this document is to provide a general guideline on writing a lab report. A lab report should not be
Premium Present tense Experiment Grammatical tense
simple mechanisms used to convert rotary motion into oscillating linear motion and vice-versa. The first of these is the slider-crank - a mechanism widely used in engines to convert the linear thrust of the pistons into useful rotary motion. In this lab we will measure the acceleration of the piston of a lawn mower engine at various speeds. The results exemplify a simple relation between speed and acceleration for kinematically restricted motions‚ which will discover. An adjustable slider-crank apparatus
Premium Internal combustion engine Classical mechanics Crankshaft
Coulomb’s Law Purpose: The purpose of this lab was to demonstrate that the force between two stationary charges is directly proportional to the product of the charges and inversely to the square of the distance between them. Coulomb’s law tells us that the force between two charges depends (1) linearly on the strength of each charge‚ and (2) inversely on the square of the distance between them. Mathematically we would write this as . Procedures Part1 Begin by removing the right side
Premium Electric charge
TITLE OF EXPERIMENT 2 : DILUTION 2.1: OBJECTIVES Upon completion of this experiment‚ students should be able to: 1. determine the concentration of coloured solution such as FeCl3 by using dilution and colour differentiating (colorimetric) techniques. 2.2: INTRODUCTION Concentration can be expressed in many different ways such as percentage volume and percentage weight etc. In laboratory‚ normally concentrations were expressed as molarity and normality. Molarity is the
Premium Concentration Chemistry
conducted on 13th August 2008 in Machines Dynamics Laboratory. The experiment was conducted in groups of four‚ and was supervised by lecturer Mr. Mohd Azahari Johan. Conducting this experiment is for fulfilling the requirements of Applied Mechanics Lab (MEC 424). A pendulum is defined as body so suspended from a fixed point as to swing freely to and from by the alternate action of gravity and momentum. It is used to regulate the movements of clockwork and other machinery. Therefore‚ a compound
Premium Pendulum
the period of oscillations to the length of the pendulum.Sources of error for this procedure included precision in both length and time measurement tools‚ reaction time of the stopwatch holder‚ and the accuracy of the stopwatch with respect to the lab atomic clock. The final result of g takes into account the correction for the error introduced using the approximation. There are opportunities to correct for the effects of mass distribution‚ air buoyancy and damping‚ and string stretching[1]. Our results
Premium Regression analysis Measurement Normal distribution
Investigation Investigate the amount of heat evolved when magnesium reacts with dilute acids. Planning What I am going to do I am going to find out how much heat is given out when magnesium reacts with a variety of dilute acids. In order to make comparisons between the acids‚ I shall use my results to work out how much heat would be given out if 1 mole of magnesium reacted with an excess of each acid. The acids I shall use are hydrochloric acid‚ sulphuric acid‚ nitric acid and ethanoic acid
Premium Hydrogen Sulfuric acid Acid
Wave Nature of Light Objective: The purpose of this lab is to investigate interference‚ otherwise known as the diffraction of light. A beam of light acts a wave‚ and we are able to use equations so calculate the wavelength of the light used. The diffraction of a straight edge demonstrates that light waves bend around straight edges‚ allowing light to enter an area of shadow. When waves are superposed‚ they reinforce each other when crests are in phase and cancel out when they are not in phase
Premium Diffraction Wavelength Light
PEES 4200W- Physiology of Exercise Lab #2: Metabolism and Energy Expenditure 1. The Respiratory exchange ratio is the ratio of the volume of carbon dioxide produced and oxygen consumed. The ratio indicates the energy that the subject is expending for indirect calorimetry‚ how efficient the subject ’s body is at utilizing the oxygen inhaled‚ as well as the main substrate being used for energy during varying intensities of exercise. During rest the volume of carbon dioxide was 0.73L/min‚ the volume
Premium Oxygen Carbon dioxide Ratio
[pic] Department of Chemical & Biomolecular Engineering THE NATIONAL UNIVERSITY Of SINGAPORE Chemical Engineering Process Laboratory I SEMESTER 4 Experiment F2 Flow Measurement in Closed Conduit and Centrifugal Pump Characteristics Name : Ang Sok Gek Chai Chang Er Cherry Chen Mingli Matriculation No. : U046941L U046938W U046882J Group : Th1 Date of Experiment : 16th March 2006 Table of Contents
Premium Fluid dynamics