of Manila) Intramuros‚ Manila COLLEGE OF NURSING Benedict’s Solution Submitted by: Marco Antonio A. Baltazar BSN IV-3 Submitted to: Prof. Marilyn Agravante Community Health Nursing Benedict’s Solution What is Benedict’s Solution? Benedict’s solution‚ deep-blue alkaline solution used to test for the presence of the aldehyde functional group‚ - CHO. The substance to be tested is heated with Benedict’s solution; formation of a brick-red precipitate indicates presence of the aldehyde
Premium Sucrose Glucose Fructose
Abstract Three tests were performed to determine the identity of unknown number 34‚ a gram stain‚ citrate utilization test‚ and a urease detection test. These tests are explained in detail‚ and the method of performing the tests is described. The tests showed that the bacterium was gram-negative bacilli that did not utilize citrate‚ and the ability to hydrolyze urea using urease. These results indicate that the identity of unknown number 34 is Proteus mirabilis. Introduction Proteus mirabilis is
Premium Bacteria Microbiology Escherichia coli
The Effect of Concentration Gradient on Osmosis Abstract: Osmosis is the passive movement of water from an area of higher concentration to an area of lower concentration‚ usually across a membrane (Thorpe 2013). Tonicity is the ability of a solution surrounding a cell to gain or lose water (Reece 2011). There are many factors that affect the rate of osmosis. These include temperature‚ surface area‚ difference in water potential‚ pressure‚ light and dark and most importantly what we will be talking
Premium Diffusion Solution Water pollution
The purpose of Module 11A was to test for the presence or absence of a particular set of functional groups through the use of wet chemical tests. In this manner‚ Unknown A which was a colorless solution‚ was first tested with 2‚4-DNP which after mixing for a few seconds formed a bright yellow precipitate. Although this confirms the presence of either a ketone or aldehyde group‚ one simple chemical test does not completely specify the presence or absence of other functional groups. Therefore‚ a second
Premium Solubility Chemistry Oxygen
The purpose of the following study is to determine where the two unknown bacteria acquired in Microbiology lab should be classified in regards to temperature‚ pH level‚ and osmoregularity. It is important to classify bacteria in order to identify them. Identification of bacteria is important because they are not only useful but potentially dangerous as well. The identification of bacteria can lead to breakthroughs in healthcare regarding treatment of old and new diseases alike. Identifying bacteria
Premium Bacteria Microbiology Microorganism
Unable to read the Gram Stain at first it was later confirmed that Unknown #7 was a gram negative bacteria. When introduced to Starch Unknown #7 produced no zone of clearing showing that it did not contain the enzyme amylase. When introduced to the Lipid Unknown #7 did produce a zone of clearing indicating that it did contain the enzyme lipase. When introduced to Casein Unknown #7 produced no zone of clearing indicating that it did not contain the enzyme protease. When streaked onto the Gelatin‚
Premium Bacteria Gram staining Staining
an Unknown Compound Purpose: The purpose of this experiment was to separate a mixture of two or more unknown compounds and identify them based on their melting point and reactivity with an acid or a base. Compound studied/Reactions: The organic solvent used in this experiment was methyl t-butyl ether (MTBE‚ 2-methoxy-2-methylpropane). The unknown that dissolved in the MTBE‚ but was insoluble in water. MBTE is very volatile and flammable. It was determined in the experiment that the unknown was
Free Chemistry Solvent Laboratory glassware
------------------------------------------------- What is the Molar Concentration (Solute concentration) of a Potato? ------------------------------------------------- ------------------------------------------------- ------------------------------------------------- Design ------------------------------------------------- ------------------------------------------------- 1. What is the dependent variable for this experiment? ------------------------------------------------- The dependent variable is the concentration (solute)
Premium Management Cost Marketing
EXPERIMENT 1 IDENTIFICATION OF UNKNOWN COMPOUNDS Date of experiment : 7th August 2012 Venue: ME204 INTRODUCTION Chemical reactions are regularly categorized into 3 types: oxidation-reduction (redox reaction)‚ precipitation (double displacement) and acid-base reaction (double displacement) Type 1: Oxidation-Reduction Reactions Oxidation-reduction processes include the movements of electrons form oxidants to reductants‚ which lead to increases in oxidation
Premium Chemical reaction
Goals The main goal of this project is to learn how to identify the properties of an unknown ionic compound. In order to do this successfully the group has to use a variety of methods and run several tests on the unknown compound. By doing this the group will be able to identify the different chemical and physical properties of the compound that will help obtain the identity of the specific compound given. The group will devise two syntheses of the compound‚ and compare them for cost effectiveness
Premium Chemistry Water Solubility