"Your data of the density of sodium chloride solutions should have produced a straight line when plotted how could this plot be used to determine the density of any concentration of sodium chloride so" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 24 of 50 - About 500 Essays
  • Good Essays

    Anhydrous sodium sulfate was added to the filtered organic solution to absorb excess water. Although water has a higher affinity towards sodium sulfate than cyclohexanol‚ excess anhydrous sodium sulfate may lead to the absorption of cyclohexane and thus loss of product. Anhydrous sodium sulfate absorbs water due to its polarity and therefore may also absorb cyclohexanol because of its polar O-H bond. If too much anhydrous sodium sulfate was added to the solution‚ part of the product would be absorbed

    Premium Chemistry Water Oxygen

    • 455 Words
    • 2 Pages
    Good Essays
  • Better Essays

    Measurement of the Densities of Water and Alcohol Phuc Truong and Shane Steele Data Collected: September 8‚ 2014 2:05 P.M. Purpose: The purpose of the experiment is to measure the densities of liquids. Specifically‚ the two liquids that were used and measured in the research were deionized water (H2O) and alcohol (C2H5OH). Methods: Density is an intensive quantity that cannot be visually identified. Therefore‚ the most straightforward approach to this problem was to record the measurements of mass

    Premium Water Volume Density

    • 595 Words
    • 3 Pages
    Better Essays
  • Good Essays

    Exploring Density Simulation Exploration: Login to the PHET Website. A basic property of any homogeneous substance is its density: the ratio of its mass to its volume. The density of a liquid or solid is an intensive property‚ which means that the density does not vary with the size of the sample but only depends upon its composition. The determination of density is a nondestructive physical process for distinguishing one substance from another. The mathematical relationship is: Density= massvolume

    Premium Density Kilogram

    • 869 Words
    • 4 Pages
    Good Essays
  • Good Essays

    radius‚ bulk density and solid density of granular materials INTRODUCTION Granular material is a group of distinct macroscopic particles‚ composed of grains or particles of solids with interstitial spaces‚ which are the spaces between the particles. Having spaces between the particles means that there are rooms left for the filling of air or liquid. This concept is applied as to use the filling of liquid to determine the volume of the particles later on. The objective of this experiment is

    Premium Bulk density Density

    • 719 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    The Effects of Population Density and Noise Paper Psy/460 The Effects of Population Density and Noise Paper Introduction There are quite a few people who believe that territoriality‚ privacy‚ and personal space mean the same thing‚ but that is not the case. As noted in this paper‚ they are completely different things. The author of this paper will describe the concepts of territoriality‚ privacy‚ and personal space; examine how these concepts have become increasingly important as populations

    Premium Noise Noise pollution Person

    • 1768 Words
    • 8 Pages
    Powerful Essays
  • Good Essays

    Sodium is a metal from group 1 of the periodic table‚ this is a metal which reacts when it needs to‚ this metal has a low melting and boiling point‚ also it is very dense‚ this shows that when reacting with other substances it will be different and this is because it will not react the same the whole time. The other thing is that this elements electron configuration is 11 which is quite low when comparing them to the other elements in the periodic table. However this metal is more reactive than

    Premium Chemical element Periodic table Atomic number

    • 731 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Density Lab Report Essay

    • 648 Words
    • 3 Pages

    DENSITY OF LIQUIDS AND SOLIDS by Lab instructor: Due date: Results and discussion: The purpose of the experiment was to determine the densities of the unknown liquid and solid as precisely and accurately as possible in order to identify them. It was carried out first on distilled water in order to rule out systematic errors. A 10 mL beaker was placed on a top pan balance and “tared”. The beaker was then removed and 10 mL of distilled water was pipetted into it before it was placed

    Premium Water Chemistry Volume

    • 648 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Water Density Lab Report

    • 815 Words
    • 4 Pages

    I. Introduction A. Purpose The purpose of this lab was to practice measuring the mass and volume of different samples and to calculate the density and specific gravity of those samples using the measurements. B. Equipment 1. Electronic balance- The electronic balance is a device used to measure the exact mass of an object 2. Graduated cylinder- The graduated cylinder is a tool used to measure the volume of a liquid 3. Pipets- Pipets are small tubes that suck up and contain liquids C. Technique

    Premium Chemistry Water Test method

    • 815 Words
    • 4 Pages
    Satisfactory Essays
  • Satisfactory Essays

    1. DATA: Table 1: Density based on dimensional analysis Trial 1 Trial 2 Trial 3 Units Mass of sample 70.5466 70.5467 70.5465 g Dimensions of sample Length 4.98 4.98 4.99 cm Width 1.21 1.22 1.21 cm Height 1.21 1.22 1.22 cm Volum of sample 7.29 7.41 7.37 cm^3 Density of sample (based on dimensional analysis) 9.68 9.52 9.57 g/cm^3 Table 2: Density based on the displacement of water Trial 1 Trial 2 Trial 3 Units Mass of sample 70.5467 70.5465 70.5466 g Final

    Premium Density Volume Water

    • 646 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Straight Line Equations and Inequalities A: Linear Equations - Straight lines Please remember that when you are drawing graphs you should always label your axes and that y is always shown on the vertical axis. A linear equation between two variables x and y can be represented by y = a + bx where “a” and “b” are any two constants. For example‚ suppose we wish to plot the straight line If x = -2‚ say‚ then y = 3 + 2(-2) = 3 - 4 = -1 If x= -2 -1 -1 1 0 3 1 5 2 7 As you can see‚ we have plotted the

    Premium Linear equation Line

    • 1871 Words
    • 8 Pages
    Good Essays
Page 1 21 22 23 24 25 26 27 28 50