Preview

Changing the oil in your motorcycle

Satisfactory Essays
Open Document
Open Document
354 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Changing the oil in your motorcycle
Nathália Batista
Advanced Writing
November 13

Changing the oil in your motorcycle

Women often have problems when they decide to buy a car or a motorcycle. Sometimes they are knew as weaker sex because they are marked by their biological functions and social. If they decided buying a motorcycle, they don´t need to be afraid whether something happen because they are completely able to do the same things as a man.
Changing the oil in the motorcycle is very important to maintain the good works of the engine and make the motorcycle have a better performance and save fuel. So, is very important to obey each step at the time to change the oil.
First, you must to locate the drain plug, which is somewhere on the bottom of the engine. When you remove the plug, the oil will drain. The second part is to remove the filter. You must to know that every time to change the oil, you must change the filter.
Continuing the procedure, cleaning and replace the drain plug when the engine is done draining. Done this, replace the filter. With a spin-on filter, lightly spread a drop or two of clean oil around the rubber seal attached to the new filter before mounting it, to create an oil-tight seal between the filter and engine.
Immediately after that, fill with fresh oil and clean the oil spilling out. After this, restart the engine to pump oil into the filter. Let the engine idle for about a minute, the shut it off and recheck the oil level. Paying attention on this part because could have any problem in your motorcycle and the new oil can drain again.
Finally, keep a close watch on the oil level and always check for leaks around the drain plug and filter.
Isn´t so easy to do this if you haven´t had a first experience doing this. But, you can use the manual´s motorcycle and read about this. Perhaps, you can talk someone more experienced and ask then some questions or ask for help whether you don´t be able to do this.

You May Also Find These Documents Helpful

  • Good Essays

    6. Use the wash bottle one last time to rinse the precipitate in the filter paper. This will remove any residual NaCl(aq) that remains with the…

    • 800 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    lab 24

    • 332 Words
    • 2 Pages

    Perform the grease spot test to the substance after filtering it. Now perform all six tests which were performed in the earlier parts.…

    • 332 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    With the transmission in neutral, start the engine and then press the accelerator lightly to get the feel of the accelerator pedal. Next, take your right foot off of the accelerator…

    • 725 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Hook up all of the belts and bolts, connect the motor to your battery, and fill the engine with oil and any other fluids such as power steering, transmission, brake, etc. that you removed while the car was without its engine. Once you’ve completed the final touches on your engine, be sure that you have assembled everything correctly; you can check with an engine building guide or manual. After putting the finishing touches on your 383 Stroker motor, finally close the hood, and you are ready for a test drive. I recommend that you take it slow at first, and make sure not to rev past the 2,000 revolution per minute mark. If everything sounds good after a few miles, you can open it up and drive…

    • 696 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Study Questions

    • 375 Words
    • 2 Pages

    48. A flooded reciprocating engine using either a float carburetor or a fuel injection system can be cleared if excessive fuel by placing the mixture control in the CUTOFF position. Turn the ignition off, open the throttle, and crank the engine with the starter or by hand until the fuel charge in the cylinders has been cleared. (Page 641)…

    • 375 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Lawn Mower Case Study

    • 301 Words
    • 2 Pages

    Class Lawn Mower Module (prime lever, pull string, gear drive, lawn catcher, push mower, lawn)…

    • 301 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    It is easy for your carburetor to get clogged up. If you leave fuel sitting inside of your pressure washer in between uses, over time, the fuel will start to evaporate. When the fuel evaporates inside of your pressure washer,…

    • 436 Words
    • 2 Pages
    Good Essays
  • Good Essays

    iii. Run the car's engine for 10 minutes before you drain the oil. Warm oil drains faster than cold oil. Although, you…

    • 846 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Chainsaw Research Paper

    • 816 Words
    • 4 Pages

    You should have the unit inspected at least once each year. This can be done yourself or by a professional. This is needed for you to make sure the device is running properly and all safety features are functioning. You should also perform a tune-up that will include replacing the oil and lubricating when needed. Sharpening the chain is also important for optimal performance.…

    • 816 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Of the services they offer, the oil change is one of the most popular—and important. Changing your oil regularly is one of the best ways to make sure your vehicle continues to run smoothly for as long as possible without requiring expensive repairs.…

    • 301 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Unclogs Without Drano

    • 543 Words
    • 3 Pages

    Place it over your drain and ensure that it completely covers the opening. There's no need to remove standing water; in fact, if your sink or tub is dry, it's better to fill it with hot water since it will help the plunger do its job.…

    • 543 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Every day, people like you drive into our service center and are confused about the type of oil that is right for their vehicle. The first step is to understand why a vehicle requires oil. A vehicle requires oil to keep it running smoothly. Oil keeps the internal parts of the vehicle lubricated and protects those parts from damage. In addition, it is vital to change the oil on a regular schedule. Finally, select the right oil for your vehicle.…

    • 158 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    When driving a car, the parts of the engine heat up with friction, and oil absorbs the heat. When it gets dirty, it cannot absorb the heat as well, and not changing the oil in a car can have harmful effects to the engine (Ulin, Don). Although changing the oil in a car every 3,000 miles might sound like a good thing for longer engine life, it should be done around 7,500 miles or more because of the harmful effects on the environment and finances. According to Jamie Cameron-Harley, “…if you can change your oil in less-frequent intervals, you not only save yourself money, you help save the environment” (Cabanatuan, Michael). When oil is changed more often, at home or by a mechanic, the chances of a spill occurring are increased.…

    • 528 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Position the large slot with the switch plunger and push it down to close the drain.…

    • 1101 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Xpresso Lube

    • 1320 Words
    • 4 Pages

    When its time to get our oil changed, you have only two choices—change it yourself or pay someone else (e.g. dealership, independent auto mechanic or a quick “ oil lube “station.) to do it for you. Many people choose quick oil-change stations because it is easier than doing it themselves and it is usually quicker and cheaper than going to a dealer or an independent mechanic.…

    • 1320 Words
    • 4 Pages
    Good Essays