Preview

Chloride Hexahydrate Lab Report

Satisfactory Essays
Open Document
Open Document
282 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Chloride Hexahydrate Lab Report
● Cobalt(II) Chloride Hexahydrate CoCl2.6H2O, was weighed in a weighing boat. The Cobalt(II) Chloride Hexahydrate was transferred into a 100mL volumetric flask dissolved in water.
● 25 mL of the dissolved was measured, using a graduated cylinder and few of the dissolved Cobalt (II) Chloride Hexahydrate, was poured into test tube. The test tube was labeled with a tape, to signify 25 mL and the spectrophotometer was used to record the U-V visible ABS (absorbance spectrum) with the wavelength of 515.
● The 75 mL remaining solution was diluted with water, filling it to a 100 mL. Also, with a graduated cylinder 20 mL of these solution was measured and little was poured into a test tube. The test tube was labeled with a tape, to signify 20 mL and

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Chemistry 116 lab review

    • 289 Words
    • 2 Pages

    The first step is to calibrate the colorimeter with0.20 M Fe(NO3)3and set the absorbance at 470 nm since it is known to keep an acidic solution throughout the entirety of the experiment. It was important to do this right at the beginning of the lab since the zeroed value of the acid was the calibration number for all of the other solutions. A total of seven solutions with different dilutions were used throughout the lab to conduct the equilibrium constant. The first step was adding 5 mL of 0.200 M Fe(NO3)3to each of the 5 test tubes. Once this was done, 0.00200 M NCS was added to the test tubes, each receiving a different amount; test tube one received 1 mL NCS-and with each test tube the amount of NCS-would increase by 1 mL, test tube 5 received 5 mL of NCS. . The next step was adding HNO3 to each test tube in different volumes; Test tube one received 10 mL of HNO3 and with each test tube the amount of HNO3 decreased by 1 mL, test tube five had no HNO3 added to it. The addition of these solutions formed five test tubes of different dilutions, but of equal volume, 10 mL each. After all of the previous trials had been completed the final step was to take each test tube and pour it into a different cuvette and measure the absorbance for each. Once the initial concentration was calculated of Fe3+, NCS and FeNCS2+ in molarity. The absorbency values were recorded and used to calculate the formation constant, K f The reference table containing volumes used in each solution is provided below…

    • 289 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    CHEM 1252 Lab Report 5

    • 1825 Words
    • 21 Pages

    For the first part of the experiment, 4.0 mL of the 0.2 M NaOH solution were poured into a small test tube. The test tube was wiped and placed into the sample holder of the spectrophotometer and the transmittance was set to 100.0 for calibration. The test tube was removed from the sample holder and 1 drop of phenolphthalein was added and inverted several times to mix. With the Spec-20 set to absorbance mode, the test tube was quickly placed into the sample holder and the absorbance was recorded every 5 seconds for 360 seconds. For the second part of the experiment, the same calibration steps were repeated and then, 2.0 mL of the 0.2 M NaOH and 2.0 mL of the 0.2 M NaCl were added to a small test tube. After this step, 1 drop of phenolphthalein was added and inverted several times to mix. With the Spec-20 set to absorbance mode, the test tube was quickly placed into the sample holder and the absorbance was recorded every 5 seconds for 360 seconds. After each part of the experiment, the test tube was removed from the sample holder and its contents were placed in the waste.…

    • 1825 Words
    • 21 Pages
    Good Essays
  • Satisfactory Essays

    Chem Lab report

    • 452 Words
    • 2 Pages

    9) Put 4mL of stock solution and 1mL of water in a test tube to make the second solution.…

    • 452 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    chem lab report

    • 1425 Words
    • 7 Pages

    2. To determine the densities of water, an unknown liquid, a rubber stopper, and an unknown rectangular solid.…

    • 1425 Words
    • 7 Pages
    Better Essays
  • Powerful Essays

    Using SN1 reaction mechanism with hydrochloric acid, t-Pentyl alcohol was converted to t-Pentyl chloride in an acid catalyzed reaction. The reaction took place in a separatory funnel designed to separate immiscible liquids. The crude product was extracted by transferring a solute from one solvent to another. The process of washing the solutions by phase transfer was used in order to remove impurities from the main solvent layer. Finally, the crude product was dried with anhydrous Calcium chloride and purified once more by simple distillation technique.…

    • 1041 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    Tube 2 Lab Report

    • 603 Words
    • 3 Pages

    As indicated by the figure, the high concentration correlated to having the highest amount of absorbance (1.006 at 300 seconds). This was followed by the medium-high concentration (0.555) and medium concentration (0.540). It can be noted that the medium concentration started off with a higher absorbance than the medium-high concentration, but the medium-high concentration had a faster increase of absorbance over time. Thus, surpassing the absorbance of the medium concentration from 270 and 300 seconds. The low concentration had the lowest amount of absorbance, with a final absorbance rate of 0.204, and did not substantially increase over the period of…

    • 603 Words
    • 3 Pages
    Good Essays
  • Good Essays

    The powdered cobalt oxalate hydrate was weighed to about 0.3 g and placed in a pre-weighed crucible. The crucible and the cobalt oxalate were then heated until the cobalt oxalate decomposed into a stable, black solid, or Co3O4. Once the crucible was sufficiently cooled, the crucible and the new substance were weighed. With this weight, the mass percent of cobalt could be determined. This step was then repeated.…

    • 1043 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Experiment: First all the materials were gathered. Pigments were separated by chromatography paper. Pigments were loaded in a line on the paper. The paper was folded in a cylinder, stapled, placed in a cylinder with solvent, and sealed with wax paper until the pigments separated. After the pigments separated the paper was taken out to dry and the separated pigments were cut out. Four groups joined together to perform the remainder of the investigation. All of the groups' pigments were separated and put into separate test tubes. Acetone was added. Using forceps, the strips of chromatography paper were "washed" of their pigment. Lastly the absorption spectrum, the absorption pattern for a particular pigment, was measured.…

    • 420 Words
    • 2 Pages
    Good Essays
  • Good Essays

    In order to complete the objective, the group used a Carolina Digital Spectrophotometer, unit M 201-1, which measures the quantity of light that solutions absorb. The spectrophotometer consists of a light source that shines through a prism which then shines through a…

    • 1159 Words
    • 5 Pages
    Good Essays
  • Better Essays

    Bio Spectroscopy Lab

    • 1273 Words
    • 6 Pages

    This investigation used spectroscopy to evaluate light absorption in different solutions. A spectrophotometer was used in the lab to determine these values. A spectrophotometer is an apparatus used to “measure the absorption of radiation in the visible and UV regions of the spectrum and allows precise at a particular wave length” (Jones et al., 2007). The amount of light absorbed by a substance is directly in relation to the concentration of the solute and also the wavelength moving through the solute (Jones et al., 2007). This is commonly referred to as Beer’s Law and can be expressed as A= εl [C]. Beer’s Law equation measures the absorbency of light, making it an effective measure as spectrophotometers give exact values for absorbency (Jones et al., 2007).…

    • 1273 Words
    • 6 Pages
    Better Essays
  • Good Essays

    Sodium Chloride Lab

    • 739 Words
    • 3 Pages

    In the experiment, we tested a sodium chloride solution. Along with the tested solution, control groups (water and sodium phosphate) were used to be help understand whether or not NaCl was a buffer. Water was the negative control group and sodium phosphate was the positive control group. If NaCl was a buffer than the pH would be stabled as the sodium phosphate buffer. If NaCl was not a buffer than the pH would fluctuate like the negative control, water. During the first trial and prior to the drops of 0.5 M of HCl acid, the pH of sodium chloride was 7.50. After the addition of 5 drops of 0.5 M of HCl, the pH decreased by 4.83 and ended at 2.67 on the pH scale. When comparing the results of the sodium chloride to the control groups, the total pH change of sodium phosphate was only…

    • 739 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Colorimetric Analysis

    • 421 Words
    • 2 Pages

    2. If this analysis was performed using a colorimeter, yellow light would be used to measure the absorbance of solutions. Why is blue light not used?…

    • 421 Words
    • 2 Pages
    Good Essays
  • Good Essays

    It is rare in a movie or TV show that a gay character has a strong lead. Him or her usually are only represented by their sexuality. Amy Zimmerman is a writer for the Daily Beast, specializing in entertainment. In an article she wrote “It Ain’t Easy Being Bisexual on TV”, she critiques the media’s portrayal of bisexuals and bisexuality. She states that most homosexual male characters are reduced to the clueless definition of “a disco-dancing, Oscar Wilde-reading, Streisand ticket-holding friend of Dorothy,” a man whom gayness in an all- encompassing personality (561). Amy provides facts and prestigious resources persuading the audience that this is actually happening in the media and television. However, there have been many different TV shows…

    • 1103 Words
    • 5 Pages
    Good Essays
  • Powerful Essays

    4. Then use the spectrophotometer to measure the #3 abs = 0.334 @ 27 sec. absorbance of each solution.…

    • 568 Words
    • 3 Pages
    Powerful Essays
  • Good Essays

    In Figure 1 and Figure 2, the data will be presented Standard Curve Graph. The relationship between the concentration of Methylene Blue and the absorbance is expected to be a direct proportion.…

    • 711 Words
    • 3 Pages
    Good Essays