Preview

Copper Chloride Lab Report

Good Essays
Open Document
Open Document
634 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Copper Chloride Lab Report
Introduction This lab proposed the question of what happens when copper chloride and iron are combined and what is the balanced equation.By completing this lab, the goal was to determine the equation and product for the reaction of iron (Fe) and copper chloride (CuCl2). It was predicted either solid iron or solid copper would form.
Methods
To begin, 6.00026 grams of copper chloride was dissolved in 50ml of distilled water in order to have a solution with charged iron and chlorine atoms. Then, 6.36 grams of iron, in the form of four iron nails, were added to the solution of copper chloride and distilled water to start the reaction, and was placed under a range hood. After 48 hours, the solution containing the nail was removed from under the

You May Also Find These Documents Helpful

  • Powerful Essays

    One hundred millilitres of water was then added into the beaker and mixed using a glass stirring rod to create a copper(II) chloride solution. The solution was observed to be light blue in colour, similar to that of the copper(II) chloride crystals. The iron nail was then placed into beaker, fully submerged in the…

    • 1905 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    Flvs Chem 04.05 Lab

    • 571 Words
    • 3 Pages

    Fill a small test tube halfway with copper (II) sulfate solution. Add a 2.0 gram iron rod to the solution and observe the reaction.…

    • 571 Words
    • 3 Pages
    Good Essays
  • Good Essays

    post lab of cucl2

    • 732 Words
    • 3 Pages

    II. Purpose: The purpose of this lab is to see how iron reacts with a copper (II) chloride solution.…

    • 732 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Chem Lab report

    • 452 Words
    • 2 Pages

    9) Put 4mL of stock solution and 1mL of water in a test tube to make the second solution.…

    • 452 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    chem lab report

    • 1425 Words
    • 7 Pages

    2. To determine the densities of water, an unknown liquid, a rubber stopper, and an unknown rectangular solid.…

    • 1425 Words
    • 7 Pages
    Better Essays
  • Powerful Essays

    Chem Lab Report

    • 1164 Words
    • 5 Pages

    .2400 grams of the unknown compound. This is done in duplicate and purple-tinted precipitates are placed in Gooch crucibles. The precipitates are suction dried using ethyl alcohol then acetone to…

    • 1164 Words
    • 5 Pages
    Powerful Essays
  • Good Essays

    Chemical Formula Lab

    • 1437 Words
    • 6 Pages

    Obtain and wear goggles. 2. Measure and record the mass of a clean, dry crucible without cover. Obtain about 1 g of the unknown copper chloride hydrate and place it in the crucible. Use a spatula to break up any large pieces of the substance by pressing the pieces against the wall of the crucible. Measure and record the mass of the crucible with compound. 3. Set up a ring stand, ring, and clay triangle for heating the sample. Rest the crucible on the clay triangle. Set up a lab burner and ignite the burner away from the crucible. Adjust the burner to get a small flame. 4. Hold the burner in your hand and move the flame slowly back and forth underneath the crucible to gently heat the sample. Do not overheat the compound. Note the color change, from blue-green to brownish, as the water of hydration is driven out of the crystals. When the sample has turned brown, gently heat the crucible for two more minutes. 5. Remove and turn off the burner. Cover the crucible and allow the sample to cool for about ten minutes. 6. Remove the crucible cover and inspect your sample. If you see any blue-green crystals, reheat the sample until the crystals have turned brown. 7. Measure and record the mass of the cool crucible of your copper chloride sample. 8. Transfer the brown solid to a clean and empty 50 mL beaker. Rinse out the crucible with two 8 mL aliquots of distilled water and pour the water into the 50 mL beaker. Gently swirl the beaker to completely dissolve the solid. Note that the color of the solution is green as the copper ions are rehydrated. 9. Measure out about 20 cm of aluminum wire, coil the wire, and place the wire in the beaker of solution so that it is completely immersed in the copper chloride solution. Note that the reaction produces a gas, elemental copper is forming on the surface of the aluminum wire, and the color of the solution is fading. The reaction will take about 30 minutes to complete. 10. When the reaction is done, the solution will be colorless.…

    • 1437 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Copper Lab Analysis Essay

    • 541 Words
    • 3 Pages

    5) For each of the reactions list the physical evidence that a chemical change was taking place (Please refer to the order in #3)…

    • 541 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Copper Carbonate Lab

    • 316 Words
    • 2 Pages

    What happens to the mass of the copper carbonate when it is heated? Give a conclusion, which describes why the mass of copper carbonate may have changed during your experiment.…

    • 316 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Chem Lab

    • 431 Words
    • 2 Pages

    The procedure for this experiment was followed using the guidelines found in CHL111 General Chemistry I Laboratory Manual Fall 2013, Chemical Reactions of Copper.…

    • 431 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Chemistry

    • 390 Words
    • 2 Pages

    Fill a small test tube halfway with copper (II) sulfate solution. Add a 2.0 gram iron rod to the solution and observe the reaction.…

    • 390 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Chemical Reactions Lab

    • 584 Words
    • 3 Pages

    This experiment was performed to demonstrate a cycle of chemical reactions involving copper. This lab will start with copper as a reactant in the first reaction through a series of five chemical forms of aqueous phase reactions and ending to calculate the percentage of recovered solid copper as a product in the last reaction of the experiment. The experiment resulted in a percent recovery from the cycle of copper reactions of an increase to 139%.…

    • 584 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    The Copper Cycle

    • 447 Words
    • 2 Pages

    In this lab, we changed copper into various forms using different chemicals and chemical reactions. The purpose of this lab is to demonstrate that the product of a chemical reaction depends on what is present at the time of that reaction. This lab also displays how matter cannot be created nor destroyed in a chemical reaction.…

    • 447 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    The purpose of this lab was to find out the reaction of iron nails and CuSO4, copper sulfate solution. Before starting the experiment, there were two possible outcomes of the reactions. CuSO4 + Fe → FeSO4 + Cu or 3CuSo4 + 2Fe → Fe2(SO4)3 + 3Cu. The ion chart showed that iron can only make two charges, +2 and +3.…

    • 276 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Chemistry

    • 641 Words
    • 3 Pages

    In a laboratory experiment, a student reacted 2.8 grams of Fe (s) (steel wool) in excess CuSO4 (aq), according to the following balanced equation: Fe(s) + CuSO4 (aq) -> FeSO4 + Cu(S).…

    • 641 Words
    • 3 Pages
    Satisfactory Essays