Preview

Determination of the Activation Energy of an Enzyme Catalysed Reaction

Satisfactory Essays
Open Document
Open Document
311 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Determination of the Activation Energy of an Enzyme Catalysed Reaction
Determination of the Activation Energy of an Enzyme Catalysed Reaction
PRACTICAL Report & Criterion Reference Grid * The expected sequence and details required for your practical report are outlined below. Please follow them closely, as they will facilitate the production of a structured report. * An introduction giving a synopsis of the experiment and the importance of rates of reaction and activation energy. This section should also state the aim of the practical (0.50-page) – 5 marks. * Materials and Method - List all materials used, conversion and adaptation made to the practical schedule. Include diagrams where appropriate. The handout with the method and procedures used throughout the practical must be included with/as part of your report. You must also indicate/include all changes and alterations made during the experiment to this section of the practical report. Do not rewrite this section! – 5 marks * Results – This section should include: * Table of data for calibration curve * Graph – calibration curve (absorbance vs. [p-NP]. * Tables of data for enzyme assay @ 25oC and 35oC, showing absorbance of each timed sample & corresponding [p-NP] read from calibration curve. * Graph of [p-NP] vs. time for each temperature * Calculation of rate of reaction @ each temp. * Calculation of activation energy * Marks will be allocated in this section as follows (Total = 35 marks): * Calibration: table of data & graph: (5+5) 10 marks. * Test samples: table of data for 25oC & 35oC: (5+5) 10 marks. * Graph showing results for 25oC & 35oC: 10 marks (5+5). * Calculation of rate reaction & activation energy: 5 marks. * Discussion – provide an analysis of the data obtained in the practical and also appropriate conclusions. You must also ensure that you use the data from your practical (including your results from your control experiment) to support the points that you are making.

You May Also Find These Documents Helpful

  • Powerful Essays

    Materials and methods for this laboratory followed those laid out in Experiment 6A on pages 56-59 of Essential Experiments for Chemistry by Morrison and Scodellaro with the following exceptions:…

    • 1905 Words
    • 9 Pages
    Powerful Essays
  • Powerful Essays

    The objective of this laboratory experiment is to observe and record the effect of reactant concentration, reactant surface area and reactant temperature on the overall rate of reaction.…

    • 2334 Words
    • 8 Pages
    Powerful Essays
  • Satisfactory Essays

    lab3c chem11

    • 314 Words
    • 2 Pages

    See Heath Chemistry Laboratory Experiments Textbook for a full set of materials and methods used in this experiment.…

    • 314 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    | * Wooden Peg * 10 ml Measuring cylinder * Curvette * Spectrophotometer * Gold Solution (HAuCl4) * Heat proof mat…

    • 1155 Words
    • 5 Pages
    Better Essays
  • Good Essays

    1) List specific materials used in your experiments (and sources of these materials). Also list any specialized equipment used.…

    • 681 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Spring Syllabus

    • 2332 Words
    • 10 Pages

    |College: Science and Technology |Required Text(s): The laboratory manual, Experiments In General Chemistry, 6th |…

    • 2332 Words
    • 10 Pages
    Powerful Essays
  • Good Essays

    Ap Biology Enzyme

    • 425 Words
    • 2 Pages

    1) The purpose of this lab was to determine the rate of enzyme activity under variety of different conditions, such as, different amount of drops of enzymes and different temperature of water. The class measured the pressure in the test tube during the reaction of the substance with, 1.5 ml of H2O2, 1.5ml of H2O and different amounts of enzyme drops, to determine how much oxygen gas is produced during the reaction since the pressure of the test tube will get higher as more oxygen gas is accumulated during the reaction.…

    • 425 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Lab Report

    • 702 Words
    • 3 Pages

    Materials: The materials that were used were Aluminum wire(12 cm), beaker (100 mL), hot plate, copper(II) nitrate (1.0 M), glass stirring rod, gloves, HCl (1.0 M), lab apron , lab marker, NaOH (1.0 M), ruler, safety goggles, test tube (13 mm x 100mm) and test tube rack.…

    • 702 Words
    • 3 Pages
    Good Essays
  • Good Essays

    The following procedures and materials listed are what you will need in order to conduct the experiments end lab results. Equipment needed to perform this experiment is a 50 ml test tube, 100 ml beaker, 250 mL Erlenmeyer flask, Buchner…

    • 878 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Density Lab

    • 832 Words
    • 4 Pages

    List the materials used in this lab, and write a brief explanation of the procedures you followed. (You do not need to retype the procedure; simply summarize your procedures you used.) Procedures: Materials:…

    • 832 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Light Reaction Lab

    • 477 Words
    • 2 Pages

    Introduction: Describe briefly the light dependent reactions and propose a hypothesis to answer the experimental question.…

    • 477 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Citation and Lab Report

    • 332 Words
    • 2 Pages

    Instructions: You will need to write a 1-page lab report using the scientific method to answer the following question:…

    • 332 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Career Comparison

    • 943 Words
    • 4 Pages

    Your assignment this week is to write your formal report’s table of contents and introduction, using formal formatting. To complete this assignment, you will need to have a good plan in place for your formal report. I encourage you to use the three-step process we’ve been studying this…

    • 943 Words
    • 4 Pages
    Good Essays
  • Better Essays

    Enzyme Formal Lab

    • 2542 Words
    • 11 Pages

    The purpose of this investigation is to figure out how temperature, pH, and enzyme concentration affect the reaction rate of an enzyme. It’s important to understand how certain factors affect enzymes because of their crucial role in the metabolic processes of life. Enzymes lower the activation energy necessary for a chemical reaction to occur, allowing vital processes such as digestion, ATP production, and DNA replication to occur efficiently. Using a Vernier Gas Pressure Sensor the rate of reaction of the enzyme catalase as it decomposed Hydrogen Peroxide in a test tube was measured and then results were put on the screen of a Macintosh computer using Logger Pro software and Vernier computer software. Several trials were then done with one factor, either temperature, pH, or enzyme concentration being altered, while the remaining two stayed constant. The rate of reaction of catalase should increase with enzyme concentration until a certain point until it reaches its limit. For temperature the rate of reaction of catalase should increase until the enzyme catalase denatures, and then after the rate should start to decrease. When exposed to different pH levels the rate of reaction of catalase should increase as the enzyme catalase reaches its optimal pH level, once it’s at that point the rate of reaction should then decrease as the pH level goes farther away from catalase’s optimal pH level. The data for the trials of pH and enzyme concentration support the expected hypotheses of how the reaction rate would be affected, however the data did not support the hypothesis made for the effects of temperature on an enzyme’s reaction rate due to divergent data from the expected results. (need this line or is conclusion and results of data and trends summarized with data supported hypotheses) ask if titel too long,,…

    • 2542 Words
    • 11 Pages
    Better Essays
  • Good Essays

    [Supplied Data: R = 8.314 J mor1 ~ 1 ; 1 Faraday= 96,500 C mol-1]…

    • 518 Words
    • 3 Pages
    Good Essays