Preview

Evaluation of Paracetamol Content in Dosage Form Using UV - Visible Spectrophotometry

Powerful Essays
Open Document
Open Document
1019 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Evaluation of Paracetamol Content in Dosage Form Using UV - Visible Spectrophotometry
Evaluation of Paracetamol Content in Tablet Dosage Form
Using UV-Spectrophotometry
Casilagan, Camela Mae C., and Jimenez, Joshua M.
Chemistry Department, College of Science
Adamson University
Ermita, Manila

1.0 Introduction
UV-Visible Spectrophotometry is a widely-used technique in Chemical and Pharmaceutical Analysis. And this method has been very useful both for Qualitative and Quantitative Applications, especially for organic compounds. Some of its advantages for Quantitative purposes arise from its wide applicability for analysis of compounds, and its apparent speed of performing analyses, with the use of modern technology applied to these instruments (Skoog, et.al, 2014).

Paracetamol,(N-(4-hydroxyphenyl) acetamide) is classified as to being part of the drugs known as “aniline analgesics” (Behera,S.,et.al, 2012) and is widely used as analgesic and antipyretic drug, together with caffeine, ibuprofen, and diclofenac sodium. Based on the United States Pharmacopeial Convention, Titrimetric, Thin Layer Chromatographic Identification Test, as well as UV spectrophotometric assay determinations have been suggested as determination methods for Paracetamol in tablet formations.

For Paracetamol, various methods have been made known in its determination in bulk form, which is based on its reaction with Iron (III) and Ferricyanide in an HCl medium (Nagedra, P., 2010), or through a simultaneous determination of Paracetamol with another component, like Etodolac (Balan, P., et.al, 2011), Thiocolchicoside and Aceclofenac (Hapse, S.A., et.al, 2011) and Tramadol HCl ( Sawant, R.,et.al., 2011).

Figure : Paracetamol.
This experiment focused on the determination of the Paracetamol content of Biogesic®, and to assess the Percentage Label Claim of the branded Paracetamol Tablet, in comparison to a USP Grade Paracetamol Standard.

2.0 Methodology
Use the number format in separating procedures. Use past-passive tense.
2.1 Materials and Reagents



References: Balan., P., et.al (2011) Simultaneous Estimation of Etodolac and Paracetamol by UV Spectrophotometric method in tablet formulation. Journal of Pharmacy Research, 4(6) 1663-1665. Retrieved from http://jpronline.info Behera et.al (2012) UV-Visible Spectrophotometric Method and Validation of Assay of Paracetamol Tablet Formation. Journal of Analytical & Bioanalytical Techniques. 3(6), http://dx.doi.org/10.4172/2155-9872.1000151 Nagedra,P. (2010) Spectrophotometric Estimation of Paracetamol in Bulk and Pharmaceutical Formulations. E-Journal of Chemistry. Volume 8(1), 149-152. Retrieved from http://e-jounals.net. Sawant., R. et.al. (2010) Validated Spectrophotometric Methods For Simultaneous Estimation of Paracetamol, Domperidone, and Tramadol HCl in pure and tablet dosage form. Journal of Chemical Metrology 4(1), 21-27. Skoog., et.al (2014) Skoog and West’s Fundamentals of Analytical Chemistry, Ninth Edition , International Edition. Brooks/Cole Publishing. United States Pharmacopeial Convention (2011), The United States Pharmacopeia, the National Formulary (USP 35 NF 30) Volume 2., 2032-2035 The United States Pharmacopeial Convention, 12601 Twinbrook Parkway, Rockville MD 20852

You May Also Find These Documents Helpful

  • Satisfactory Essays

    Isolation of Aspirin: The organic filtrate was extracted through a separatory funnel with 32 mL 5% sodium bicarbonate to produce an aqueous layer and a dichloromethane layer. 7.2 mL 6 M hydrochloric acid were added to the aqueous layer until the pH was 2. The mixture was then cooled in an ice/water bath for 10 minutes. The aspirin was collected by vacuum filtration. After it dried, it yielded 0.93 g (30.9 % of original Panacetin).…

    • 291 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    The purpose of this experiment was to perform the separation of aspirin, sucrose and an unknown analgesic, which are constituents of Panacetin using the methods of filtration, extraction, and purification…

    • 1744 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    The purpose of this experiment was to create and obtain pure acetaminophen. p-aminophenol and acetic anhydride were used to create acetaminophen and acetic acid. The acetic acid mixed with acetaminophen created an impure sample, which was purified through the addition of a water/methanol solution. The percent recovery of acetaminophen from the impure sample to the pure sample was 76%. The melting point of the pure sample was 167C - 169C.…

    • 860 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Aspirin, Caffeine and Salicylamide were extracted from an over-the-counter pain reliever (BC Powder). These components were separated by manipulating their solubilities by adjusting the acidity and basicity of the solution. By doing this, the three components were forced into conjugate acid (or base) forms, causing selective solubility in either an aqueous or organic solvent. These layers were then separated by use of a separation funnel. Once separated, the components extracted were characterized by measuring the melting point and performing a TLC analysis. Also, the recovered aspirin from the first part of the experiment was recrystallized and compared to that of the isolated aspirin.…

    • 1653 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    Panacetin Lab Report

    • 1439 Words
    • 6 Pages

    The second experiment of the semester focuses on separating and identifying the components of Panacetin, which is a common medication that relieves pain. The label reveals that Panacetin is composed of sucrose (10%), aspirin (40%), and Tylenol (50%). Although this information is reported, the true composition of Panacetin is questionable. While sucrose and aspirin are present in Panacetin, Tylenol may be replaced by an unknown component (acetanilide or phenacetin). Separation of the components of a sample of Panacetin may prove valuable in identification of the unknown component, as well as the true percent composition of each component of Panacetin.…

    • 1439 Words
    • 6 Pages
    Powerful Essays
  • Satisfactory Essays

    In this lab the results were recorded in two sections separated in sucrose and aspirin. The sucrose results were recorded as being in a solid state, having a white color and having a weighed mass of .21 grams. The aspirin results were recorded as a solid state, having a white color and having a weighed a mass of .10…

    • 479 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    The purpose of this experiment is to investigate the composition of a simulated pharmaceutical preparation Panacetin, a proposed type of pain-killer. Panacetin is typically made up of sucrose, aspirin, and acetaminophen, but the third component in this experiment is unknown. The unknown component is suspected to be a chemical relative of acetaminophen, either acetanilide or phenacetin. Using techniques such as extraction, evaporation, and filtration, the three components will be isolated based on their solubilities and acid-base properties. The percent composition of Panacetin will also be deduced based on the masses of the three dried components; this is done to verify the composition attained is consistent with those listed on the preparations label. As a result of this investigation, my teammates and I allowed the Panacetin to undergo gravity filtration and separation techniques in order to identify whether there are any discrepancies in the components of the Panacetin. Furthermore, recrystallization and purification methods were used to determine if the unknown substance were similar in properties to either of the suspected unknown substances by comparing factors such as melting points to the chemical properties of phenactin and acetanilide. The results were as expected, based on the molecular weights and ratios of each separated chemicals, as well as the boiling point of the unknown it was determined that these ranges were close enough to indicate that the label is reasonably accurate in its composition. To add on however the identity of the unknown component differed from what the label indicated. In the end, the percentage composition attained based on our observations and yield confirmed that indeed the chemical composition of Panacetin were as indicated on the preparations label. The identity of the unknown component however suggested that the preparation did not contain acetaminophen as indicated, but instead was consistent with the chemical properties…

    • 305 Words
    • 2 Pages
    Good Essays
  • Good Essays

    CHEM 1252 Lab Report 5

    • 1825 Words
    • 21 Pages

    For the first part of the experiment, 4.0 mL of the 0.2 M NaOH solution were poured into a small test tube. The test tube was wiped and placed into the sample holder of the spectrophotometer and the transmittance was set to 100.0 for calibration. The test tube was removed from the sample holder and 1 drop of phenolphthalein was added and inverted several times to mix. With the Spec-20 set to absorbance mode, the test tube was quickly placed into the sample holder and the absorbance was recorded every 5 seconds for 360 seconds. For the second part of the experiment, the same calibration steps were repeated and then, 2.0 mL of the 0.2 M NaOH and 2.0 mL of the 0.2 M NaCl were added to a small test tube. After this step, 1 drop of phenolphthalein was added and inverted several times to mix. With the Spec-20 set to absorbance mode, the test tube was quickly placed into the sample holder and the absorbance was recorded every 5 seconds for 360 seconds. After each part of the experiment, the test tube was removed from the sample holder and its contents were placed in the waste.…

    • 1825 Words
    • 21 Pages
    Good Essays
  • Good Essays

    Pre-Lab: Analgesic drugs are known for reducing pain, while antiseptic drugs reduce symptoms such as fevers and swelling. However, some of these drugs can reduce both illnesses. To obtain a pure compound in these drugs, the scientist needs to separate the desired compound by taking advantage of the different physical and chemical properties. Such as; different boiling points, melting points and their solubility properties. To do this a chemist can also asses the differences between acidic and basic substances when they are added to water soluble mixtures. Within this current experiment I will asses the pharmaceutical preparation of Panacetin, by using it 's solubility along with other organic molecules. We know that Panacetin is made up of sucrose, aspirin and some other unknown substance. We know the substance has to be Phenacetin or Acetanilide. To help solidify our reasoning, we need a % recovery of 8-12% sucrose, 35-45% aspirin and 45-55% unknown.…

    • 1948 Words
    • 56 Pages
    Good Essays
  • Good Essays

    chemsitry assignment

    • 1068 Words
    • 5 Pages

    Aim Counterfeit pharmaceuticals are a big concern regarding the issue of medicines due to fake versions containing either the wrong ingredients or inaccuracy of the active ingredient which can cause toxicity issues in patients using these products. The aim of this experiment is to find if the percentage composition of the label (50% paracetamol, 40% aspirin and 10% sucrose) matches that of the percentage composition of the powder by following 10% ranges of each component in the powder. I am going to do this via a number of methods including vacuum filtration, heating, extraction and evaporation.…

    • 1068 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Acetaminophen is a common analgesic used to treat mild pain. We synthesized acetaminophen by reacting p-aminophenol and acetic anhydride. The amine group on the p-aminophenol reacted with the center oxygen atom on the acetic anhydride to form an amide. We reacted 0.210g of p-aminophenol with 0.240ml of acetic anhydride in the presence of heat, and then cooled the solution in an ice bath until crystals formed. The solid acetaminophen was filtered from the solution and then subjected to a recrystallization using a 50:50 water-ethanol solvent. 0.1484g of crude acetaminophen was measured and after purification 0.0669g of pure acetaminophen was collected. A percent yield of 23% was calculated from our theoretical and actual yield. The melting point…

    • 142 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Tlc Lab

    • 515 Words
    • 3 Pages

    We used this specific eluent because it is polar. Since the analgesics used in this lab contained different functional groups, some were more polar than others. So, the polar eluent with a non-polar TLC plate assists in illustrating the different polarity strengths and determining the analgesic drugs in a mixture. Furthermore, the acetic acid component of the eluent used helps remove the excessive Ibuprofen and Acetylsalicylic Acid. This is done by restraining their ionization. Overall, ethyl acetate containing 0.5% acetic acid was effective because the various analgesics in Anacin, Excedrin, Motrin, and No-Doz were all clearly separated and…

    • 515 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    evaluation of the content of paracetamol in the bulk, dosage forms and in urine, a body fluid. Separation…

    • 3534 Words
    • 26 Pages
    Powerful Essays
  • Satisfactory Essays

    9.06

    • 500 Words
    • 2 Pages

    Spectrophotometry is a drug test that uses ultraviolet and infrared light. This test tells whether a drug is present or not, and then can be used to compare the measurements of different drugs.…

    • 500 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    CHEM 2303: ANALYTICAL CHEMISTRY II LECTURE 1 – INTRODUCTION, SAMPLE PREPARATION AND SPECTROPHOTOMETRY WHY STUDY ANALYTICAL CHEMISTRY? To gain a knowledge of the methods and strategies that have been developed to investigate the nature of the chemistry around and within us.…

    • 5545 Words
    • 43 Pages
    Powerful Essays

Related Topics