Preview

Michael King Lab

Good Essays
Open Document
Open Document
520 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Michael King Lab
Information of Michael King’s lab sheet can state two conclusions. The first conclusion that can be stated from information of the lab is water seeped through some of the oil. The density of the water was 1.1 g/mL and the soap was 1.446 g/mL, the soap was clearly denser than water. For proof that the water seeped through the soap Michael King’s observation sheet of water stated: “The water is leaking down into the soap, but still sits on top of the dish soap.” Later through his observations it elaborates, “The cooking oil sits on top of the water, but the water is still seeping through the soap.” This is inconsistent to King’s predictions because he did not include that the water will seep through in his predictions. The second conclusion that can be pulled from King’s lab information is that the water seems to be the only liquid that seeped through another liquid. …show more content…
The reason behind it is unknown; perhaps it’s a reaction between the water and oil. This might be inconsistent with his predictions because he didn’t not think that the water would be the only liquid to leak through or have a reaction with the oil if that’s the case. Errors that would affect King’s final results would be that water didn’t “perfectly” sit on top of the dish soap, in result King couldn’t write that every liquid perfectly sat on top of each in his conclusion. This cannot be documented because the water seeped through into the dish soap, this gives the information that the water technically did not stay on

You May Also Find These Documents Helpful

  • Better Essays

    Young Ung Son Lab

    • 621 Words
    • 3 Pages

    We can predict that more mass that you work on makes more work to do which means when mass increases, work increases too. In this lab, the mass of shoe is twice heavier than the mass of calculator. Therefore we can guess the difference of work because in the calculating procedure, height which is 0.9m and the gravity which is 9.81 apply same to both of mass. Adding, subtracting, multiplying and dividing of both factors in each side make same ratio but different results.…

    • 621 Words
    • 3 Pages
    Better Essays
  • Satisfactory Essays

    Calorimetric Analysis Lab

    • 282 Words
    • 2 Pages

    We measured its relative mass and recorded in our lab notebook. The liquid was consequently poured into the cylinder and the volume measured. To finish off the experiment, section three was conducted in order to compare samples of known liquids. Samples of olive oil, isopropyl, and water were obtained. Test tubes were dried and ready for samples to be placed in each. First, we placed olive oil in with isopropyl, we then saw that isopropyl was clearly above the olive oil. Next, we placed olive oil in with water and saw that olive oil was clearly above the water. Finally, we placed water in with isopropyl and saw that the isopropyl was above the water. With this section, we completed our experiment and cleaned the materials used and put them…

    • 282 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Indicating the honey with the density of 1.52g/mL is lower than the weight of the screws, as they had a lower buoyancy. Whereas the dish soap is where most objects seem to sink to. The same rule applies to the layer of dish soap. The tomato and the lego pieces are heavier than the dish soap fluid; however, not heavy enough for the fluid to sink into the corn syrup. The grape is just below the water, proving that its mass is just great enough to sink through the water, not floating, nor sinking to the layer before, the corn syrup.…

    • 1008 Words
    • 5 Pages
    Good Essays
  • Good Essays

    1. Precipitate remains in beaker were washed out with a small amount of distilled water…

    • 1507 Words
    • 7 Pages
    Good Essays
  • Satisfactory Essays

    Lab 9

    • 355 Words
    • 4 Pages

    Great Graph Match. Analyze the temperature and precipitation graphs of the different cities and try to match them up to the correct biome. Continue until you have them all correct. Then list the city and the biome in the table below. How many tries did it take you?…

    • 355 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Muscle Lab

    • 657 Words
    • 3 Pages

    Jan Swammerdam, who demonstrated that an isolated frog muscle could be made to contract when the sciatic nerve was irritated with a metal object, conducted the first muscle experiments between 1661 and 1665. Later, between 1737-1798 Luigi Galvani determined that frog muscle responded to electrical currents. The kymograph, which was invented in the late 1840’s lead to the revolution of experimental physiology because it enabled muscle contractions to be analyzed and recorded. The muscle cell or fiber is the basic unit of a muscle. The frog gastrocnemius muscle contains many muscle fibers. Each of these fibers has its own threshold and responds all-or-none (twitch) when stimulated. All of the fibers in a muscle do not have the same threshold and when a stimulus is applied to the muscle does not necessarily excite all the fibers in it.…

    • 657 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Irresistible Lab

    • 1541 Words
    • 7 Pages

    The over all goal of the Irresistible lab was to verify a buffer’s ability to resist changes in pH with consecutive 1mL additions of either a strong acid (HCl) or base (NaOH). The experiment entailed preparing a combination 10 buffered and non-buffered solutions and then monitoring the pH changes as a strong acid or base was added to the solution. By performing this experiment, it was found that with increasing amounts of buffer in the prepared solutions there was better resistance against pH changes. This was because the strong acid or base was converted to it’s weak conjugate. The solution with little or no buffer had no resistance to pH changes. The Irresistible…

    • 1541 Words
    • 7 Pages
    Better Essays
  • Good Essays

    On our first trial, we only put in blue, green, red, and yellow mixtures inside the test tube. Before we even put in the orange solution, the yellow liquid started to mix in with the red solution. It meant that the yellow sugar water was more dense than the red sugar water. On our second trial, we tried to put the green mixture first to see what would happen. When we put the green mixture inside the test tube, we decided to experiment and put in the yellow solution. The second we put the yellow mixture in, it immediately mixed in with the green. This proved to us that the yellow mixture was more dense than the green mixture. Next, we tried to put the blue solution first, the green solution second, the red mixture third, the yellow mixture next, and the orange sugar water on the top. The test tube started turning a dark purple color. The orange was more dense than most liquids. Then, we tried blue, green, red, and orange. The red and the orange mixed and the mixture turned black. On our final trial, we did blue, orange, green, yellow, and red. The sugar waters did not mix in this order. The blue was the most dense. The orange was not as dense as the blue, but was more dense than the green. The green was more dense than the yellow, but was not as dense as the orange. The yellow was not as dense as the green, but was more dense than…

    • 374 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Beach Ball Experiment

    • 592 Words
    • 3 Pages

    As the temperature hit the melting point and was slowly rising (2:30 - 0*C, 3:00 - 0*C, 3:30 - 0.5*C, 4:00 - 1*C, 4:30 - 1.5*C = first 5 trials after we lit the flame) the ice started melting. Energy was entering into the liquid as it was melting, which made the molecules able to slowly spread apart from each other. And as soon as the temperature hit the boiling point (15:30 - 89*C, 16:00 - 91*C, 16:30 - 93*C, 17:00 - 93*C, 17:30 - 94*C = last 5 trials after ice hit boiling point) The liquid was started turning into gas, and more energy was entering the liquid as it was turning into water vapor. The molecules started to spread apart faster until they were not touching at all. Our evidence for 1.4 about air is that air temperature can affect things drastically or not, because when things such as ice (A solid) reaches the melting point it turns into a liquid, and then when they reach the boiling point the liquid turns into a gas evaporating into the air. Because we tested this by putting water into a beaker and heating it up and first the ice melted, then boiled. Our science knowledge for this is that when we heated up water the ice in the beaker started to melt and the ice turned into liquid and then when the liquid reached the boiling point the liquid start to boil turning into gas. In demonstration 1 the cup was placed in the water right side up, the water overflowed the beaker. The air escaped the cup which made it able to go fully under the water. So the paper towel ended up getting wet. We know this because when we read pages 28 and 29, we learned that air has volume, and then on pages 32 and 33, we learned that air has mass. Matter is made up of volume and…

    • 592 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    The purpose of this experiment was to find out if all liquids diffuse in the same way.…

    • 2114 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    In the lab we performed several experiments. The recorded experiment was the volume and density experiment. For this experiment I hypothesized that the water is denser than alcohol.…

    • 508 Words
    • 3 Pages
    Good Essays
  • Better Essays

    The aim of this experiment was to determine the density of water and, of unknown solutions, by being as accurate as possible, by pipetting and weighing the solutions.…

    • 1287 Words
    • 6 Pages
    Better Essays
  • Satisfactory Essays

    Wk5 Lab Joseph Laguerre

    • 287 Words
    • 4 Pages

    Write a program that draws a series of eight concentric circles. The circles should be separated by 10 pixels. Use the drawArc method.…

    • 287 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    In both of these experiments the product was dipped into the liquid and then the remaining of the liquid was measured to see how much was left and whichever one had the least amount left came out on top.…

    • 1074 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Peanut Lab

    • 729 Words
    • 3 Pages

    In this experiment, we will use a Calorimetry technique to determine the heat of combustion of a peanut and a marshmallow. Using a simpler version of a calorimeter, we will burn a peanut. First we measure the peanut, and after burning we will measure the waste product left after the burning of the peanut. We will measure the volume of water that melted due to the heat generated by the peanut and the marshmallow. This experiment will show us how many calories are actually in the foods we eat as opposed to the amount of calories listed on the label.…

    • 729 Words
    • 3 Pages
    Satisfactory Essays