Preview

Synthesis of Dibenzalacetone by the Aldol Condensation

Better Essays
Open Document
Open Document
1119 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Synthesis of Dibenzalacetone by the Aldol Condensation
Experiment 11: Synthesis of Dibenzalacetone by the Aldol condensation
Introduction:
The Aldol condensation reaction, under basic conditions, involves the nucleophilic addition of an enolate ion to another carbonyl group. The resulting product, a beta-hydroxy ketone or aldehyde, is called an aldol because it contains both and aldehyde group and the hydroxy group of alcohol. Condensations, including aldol condensation, combine two or more molecules, typically with a loss of a smaller molecule (including water or alcohol). In the presence of a base, the aldol condensation occurs by a nucleophilic addition of the enolate ion (a strong nucleophile) to a carbonyl group. The final step, protonation, gives the desired aldol. In this lab, the Aldol condensation reaction took place in basic conditions, with NaOH and EtOH, however, this reaction can also take place in acidic conditions as well. The enol can serve as a weak nucleophile to attack a protonated carbonyl group.

Mechanism:

Side reactions:

The first is an example of self-condensation. In this lab, we were performing a mixed condensation, so this side reaction would not be favorable. The second reaction would occur if there was excess acetone in the reaction, causing acetone to further react with the desired final product. The last side reaction is due to not enough acetone in the reaction, only able to add to one side of the carbonyl and ultimately in the wrong position. This is why it was important to pay special attention to the amounts of reactants added to the mixture.

Experimental:
In a medium sized test tube * Add 4 mL of 3M NaOH solution * Add 3 mL of 95% ethanol * Add .424 g of benzaldehyde * Add .116 g of acetone
Take a TLC of mixture
Cap tube with cork and shake mixture vigorously for 30 minutes * Add 3 mL of water into test tube and cap the tube and shake vigorously
Repeat 3 times
Remove the liquid from test tube using Hirsch funnel vacuum filtration
Dry and



References: Wade, L.G. (2006). Organic Chemistry. Upper Saddle River, NJ: Prentice Hall Weldegirma, S. Experimental Organic Chemistry Laboratory Manual. Department of Chemistry; University of South Florida, Fall 2011/spring 2012. Pg 93-95. http://riodb01.ibase.aist.go.jp/sdbs/cgi-bin/direct_frame_top.cgi (literature IR for dibezalacetone)

You May Also Find These Documents Helpful

  • Powerful Essays

    Put an empty beaker at the end of the tube to catch the substance that flows through the tube.…

    • 1126 Words
    • 5 Pages
    Powerful Essays
  • Satisfactory Essays

    paper1

    • 374 Words
    • 2 Pages

    In the hood, into two nested test tubes, add 10 mL of cyclohexane from a buret.…

    • 374 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Experiment C

    • 172 Words
    • 1 Page

    8. The samples are added to acetone to quench the reaction because the hydrolysis reaction is slower in acetone, which is effective for quenching.…

    • 172 Words
    • 1 Page
    Satisfactory Essays
  • Powerful Essays

    The objective of this experiment is to successfully perform a dehydration of 1-butanol and 2-butanol, also dehydrobromination of 1-bromobutane and 2-bromobutane to form the alkene products 1-butene, trans-2-butene, and cis-2-butene. The dehydration reactions react under and acid-catalysis which follows an E1 mechanism. It was found that dehydration of 1-butanol yielded 3.84% cis-2-butene, 81.83% trans-2-butene, and 14.33% 1-butene, while 2-butanol is unknown due to mechanical issues with the GC machine. For the dehydrobromination, with the addition of a strong base that can abstract a proton, which then pushes off the leaving group and a new sigma bond makes a new π-bond all at one time, this is follows E2 mechanism. It was found that the dehydrobromination of 1-bromobutane yielded 100% 1-butene, while 2-bromobutane yielded 13.09% cis-2-butene, 49.95% trans-2-butene, and 36.97% 1-butene.…

    • 1583 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    Chemical Reactions Lab

    • 1383 Words
    • 6 Pages

    Dispose of the solutions and any precipitates in the waste beakers located in the hoods. Wash your test tubes with soap and water. Rinse with tap water, then deionized water. 5. Add an amount equivalent to the size of a small pea of baking soda (sodium hydrogen carbonate) to a clean test tube. Add 10-20 drops of vinegar. (Vinegar is an aqueous solution of acetic acid, HC2H3O2). Record your observations. 6. IN THE HOOD, add an amount equivalent to the size of a small pea of sodium sulfite, Na2SO3, to a test tube. Add 10-20 drops of 6 M HCl. Record your observations.…

    • 1383 Words
    • 6 Pages
    Good Essays
  • Satisfactory Essays

    Macromolecules Lab

    • 613 Words
    • 3 Pages

    Put the test tube into the water bath that is on top of a hot plate…

    • 613 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Gas Chromatography Lab

    • 648 Words
    • 3 Pages

    E1 reactions are two-step unimolecular reactions. The first step of an E1 reaction occurs when a leaving group, which consists of a weak base, leaves an organic compound, leaving an intermediate carbocation. In the second step, a carbon on the organic compound is deprotonated by a Lewis base, resulting in the formation of an alkene. The dehydration reactions of 1- and 2-Butanol with sulfuric acid occur through an E1 mechanism, so they follow the steps previously…

    • 648 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Introduction- The synthesis of Tetraphanylcyclopentadienone was a further example of the adol condensation reaction. Tetraphenylcyclopentadienone was the final product of the three step process shown in earlier experiments. The products that were produced in one experiment were used as the reactants in the next. In the beginning of the adol…

    • 608 Words
    • 3 Pages
    Good Essays
  • Good Essays

    French Questions

    • 900 Words
    • 3 Pages

    8) Fill test tube #3 with a piece of liver and sand. Then place this test tube into a breaker of ice. Set this beaker aside for as long as possible.…

    • 900 Words
    • 3 Pages
    Good Essays
  • Good Essays

    1. Measure 50 mL tap water using the graduated cylinder then add it to one of the beakers…

    • 1094 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Overview: In this experiment, you will perform two reactions that transform alkenes into diols. While similar in functional group transformation, these reactions may lead to stereochemically different products. The two possible products are diastereomers of one another, and therefore have different physical chracteristics. After performing the reactions, you will characterize the crude reaction mixtures to determine if you formed a mix of trans enantiomers, the cis product, or a mixture of cis and trans diols. (Figure 1)…

    • 540 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Butanol Lab

    • 466 Words
    • 2 Pages

    2. Add 10 drops of concentrated HCl to each of the three test tubes. Shake the mixtures very gently.…

    • 466 Words
    • 2 Pages
    Good Essays
  • Good Essays

    9. Fill your cylinder with enough water so that when the sample is dropped in, it will be completely submerged (80mL was used in this experiment).…

    • 836 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Strawberry Extraction Lab

    • 745 Words
    • 3 Pages

    3) Massage solution and strawberry mix for an additional amount of time (remembering to get as few bubbles as possible from massaging)…

    • 745 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Simple Sugar Lab

    • 608 Words
    • 7 Pages

    substance to each test tube. then add 10 mL distilled water. swirl gently to mix.…

    • 608 Words
    • 7 Pages
    Good Essays