Preview

Conductivity vs. Molarity Essay Example

Good Essays
Open Document
Open Document
576 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Conductivity vs. Molarity Essay Example
Introduction: Athetles consume Gatorade to replenish the electrolytes lost through sweat. Since Gatorade has a high concentration of solutes such as electrolytes it allows for the nervous system to respond faster to changes in the body. “Electroyltes are molecules that can dissociate into ions and conduct electrical currents” (EduChange 2002). These molecules, can move freely, once dissociated into ions allowing for there to be a electrical current. Because elcetroyltes can not conduct electrical currents in there solid form they are put in a solution to dissociate. The purpose of Lab 32 was to determine the effect that the concentration of a solue has on the conductivity of an electrolytic solution. If NaCl is added to water to create an electrolytic solution then it will create a stronger electrical current than distilled water because NaCl is a strong electrolyte that can conduct electricity well due to its ability to dissociate into ions.

Materials and Methods: In order to test for the effect that the concentration of a solute has on the conductivity of an electrolytic solution. Four beakers were filled with 100 ml of distilled water. A conductivity tester was then put into the first beaker of water to test for the conductivity of the control. 20 grams of salt was then weighed on a scale, 2g of salt was placed in 1 beaker to create a .346 molar solution. 5g in the next to create a .865 molar solution and 10g on salt was placed in the last beaker to create a 1.73 molar solution. The solutes were stirred until they were completely dissolved in the water. The conductivity tester was again used, and placed into the 3 beakers to test for the conductivity. For each beaker the conductivity was recored. After the data was recored the materials were put away and post – lab questions were answered.

Trends: For both trials there was a sharp increase in conductivity from the control to beaker 3 (filled with 5g of NaCl). But the level of conductivity in all the

You May Also Find These Documents Helpful

  • Satisfactory Essays

    It is important to use de-ionized water in this experiment because you don’t want the electrolytes in the water to affect the aqueous solutions conduct an electric current, especially if it can’t.…

    • 728 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    State of Matter Sleuth

    • 579 Words
    • 3 Pages

    To determine the ionic compound from compound B and compound C, a conductivity test and solubility test were carried out. Both compounds were mixed with water. Both compounds were soluble in water. Therefore, the type of compounds could not yet be determined. Both solutions were then tested with a conductivity meter. The larger value of conductance of solution of compound C significantly assured that compound C is the ionic compound whereas compound…

    • 579 Words
    • 3 Pages
    Good Essays
  • Good Essays

    The purpose of the experiment was to find the percent of water in Epsom salts by heating it. To find the percent of water in a hydrate, the hydrate must be heated. The experiment did not only show how dehydration occurs, but this experiment also gives an accurate and definite portrayal of the amount of water that is removed…

    • 604 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Lab 9

    • 915 Words
    • 4 Pages

    3. Test all three types of water using the conductivity apparatus by carefully placing the exposed metal portions of the electrodes in the solutions to be tested.…

    • 915 Words
    • 4 Pages
    Better Essays
  • Powerful Essays

    Actions Taken: I labeled six test tubes in accordance with their respective Sample number and placed them on the test tube rack. I then placed a pea-sized amount of each sample in their corresponding test tube. Following that, I utilized the graduated cylinder to measure and transfer 5 mL of distilled water into each of the six test tubes. I then placed a rubber stopper on Sample #1, and shook vigorously to determine its solubility. I repeated this with each sample, and then recorded my results in Data Table 1.…

    • 2444 Words
    • 10 Pages
    Powerful Essays
  • Satisfactory Essays

    Biolab 3

    • 745 Words
    • 4 Pages

    The purpose of this week 4 iLab was to find the unknown concentration of a NaCl solution using a standard curve of conductivity. Because water contains very few ions it does not conduct electricity very well. When NaCl solution is dissolved in water, the solution conducts very well, because the solution contains ions. The ions come from the table salt, whose chemical name is sodium chloride. Sodium chloride contains sodium ions, which have a positive charge, and chloride ions, which have a negative charge. Because sodium chloride is made up of ions, it is called an ionic substance. After completing the experiment and plotting each conductivity value I found that as the NaCl increased in concentration and so did the conductivity…

    • 745 Words
    • 4 Pages
    Satisfactory Essays
  • Better Essays

    Coordination Complex Lab

    • 716 Words
    • 3 Pages

    Some of the solution was removed and more deionized water (1.50mL) was added to the solution. A cuvette was filled with deionized water and another with the solution. Each cuvette was filled to the same level. The transmittance of the solution was found at 400nm and then consecutively recorded at intervals of 25nm. Absorbance was calculated from percent transmittance and then plotted on a graph as a function of…

    • 716 Words
    • 3 Pages
    Better Essays
  • Powerful Essays

    Did the Na+/Cl- diffuse from the left beaker to the right beaker? If so, with which membrane(s)? yes, 50 MWCO, 100 MWCO, 200 MWCO…

    • 760 Words
    • 4 Pages
    Powerful Essays
  • Powerful Essays

    PURPOSE: To see which solutions are soluble and which are not. We were able to see this by mixing certain solutions together and observing changes that occurred.…

    • 978 Words
    • 4 Pages
    Powerful Essays
  • Satisfactory Essays

    (Brown 4.11) When asked what causes electrolyte solutions to conduct electricity, a student responds that it is due to the movement of electrons through the solution. Is the student correct? If not, what is the correct response?…

    • 1513 Words
    • 7 Pages
    Satisfactory Essays
  • Satisfactory Essays

    In this lab we will work with aqueous solutions of ionic substances and determine if they are soluble. If the solution appears milky than it is known as a precipitate reaction, meaning it is soluble, and that the ions separated and became surrounded by water. Precipitates in this experiment are electrically uncharged. To identify which compounds are soluble or insoluble we can check the chart in the textbook containing solubility rules and tables. The goal of the experiment is to study and observe the nature of ionic reactions.…

    • 620 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Conductivity Lab Report

    • 629 Words
    • 3 Pages

    2). Did any of the liquids conduct an electric current? If so, which one(s), and please explain why or why not thoroughly?…

    • 629 Words
    • 3 Pages
    Good Essays
  • Better Essays

    The conductivity of each is represented by the brightness of the light. Brighter light indicates more conductive solution while less conductive solutions only produce dim light. This table is used to clearly establish the conductivity of the different solutions; 0 for non-conductor- to 4 for excellent conductor. Scale of Conductivity Scale…

    • 1008 Words
    • 5 Pages
    Better Essays
  • Good Essays

    College essay

    • 3254 Words
    • 14 Pages

    An aqueous solution containing 0.050 M of ion and 0.072 M of is prepared, and the progress of the reaction followed by measuring []. The data obtained is given in the table below.…

    • 3254 Words
    • 14 Pages
    Good Essays
  • Powerful Essays

    Conductivity

    • 1845 Words
    • 8 Pages

    There are three main sections to this module: terrestrial coordinates, celestial equatorial coordinates, and understanding how the ecliptic is related to seasons on the Earth. Each of these sections has its own simulator(s). The background material necessary to utilize these tools is contained in each section.…

    • 1845 Words
    • 8 Pages
    Powerful Essays