Preview

Linear Variable Displacement Transducer (Lvdt)

Good Essays
Open Document
Open Document
1050 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Linear Variable Displacement Transducer (Lvdt)
Linear Variable Displacement Transducer (LVDT):
A very basic transducer which is always useful in the field of instrumentation, I have studied about this in my college days. Now let me explain about the LVDT with its Principle of Operation and I will explain how it is constructed for its well known operation and you can understand the working of LVDT.
Principle of LVDT:
LVDT works under the principle of mutual induction, and the displacement which is a non-electrical energy is converted into an electrical energy. And the way how the energy is getting converted is described in working of LVDT in a detailed manner.
Construction of LVDT:

LVDT consists of a cylindrical former where it is surrounded by one primary winding in the centre of the former and the two secondary windings at the sides. The number of turns in both the secondary windings are equal, but they are opposite to each other, i.e., if the left secondary windings is in the clockwise direction, the right secondary windings will be in the anti-clockwise direction, hence the net output voltages will be the difference in voltages between the two secondary coil. The two secondary coil is represented as S1 and S2. Esteem iron core is placed in the centre of the cylindrical former which can move in to and fro motion as shown in the figure. The AC excitation voltage is 5 to 12V and the operating frequency is given by 50 to 400 HZ.
Working of LVDT:
Let's study the working of LVDT by splitting the cases into 3 based on the iron core position inside the insulated former.
Case 1:
On applying an external force which is the displacement, if the core reminds in the null position itself without providing any movement then the voltage induced in both the secondary windings are equal which results in net output is equal to zero
i.e., Esec1-Esec2=0
Case 2:
When an external force is appilied and if the steel iron core tends to move in the left hand side direction then the emf voltage induced in the secondary

You May Also Find These Documents Helpful

  • Better Essays

    Iron- Transformers are used widely in consumer electronic products to step down the supply voltage to a level where it will be suitable for the low voltage circuits they contain. In these kinds of applications the transformer could also act as a key safety component that electrically isolates the end user from direct contact with the extremely dangerous supply…

    • 1562 Words
    • 7 Pages
    Better Essays
  • Satisfactory Essays

    Induction is when one electrical field from a conductor can create a current in another conductor.…

    • 439 Words
    • 3 Pages
    Satisfactory Essays
  • Powerful Essays

    Physics Quiz

    • 934 Words
    • 4 Pages

    5. If the current through a solenoid is increasing, there is a voltage drop across the solenoid in the direction of the current.…

    • 934 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    2. If the solenoid below is being pulled away from the loop shown, in what…

    • 588 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    20. What removes the starting winding from the electrical circuit of an open type split phase motor once it reaches 75% of its operating speed?…

    • 606 Words
    • 3 Pages
    Powerful Essays
  • Satisfactory Essays

    Physics Lab

    • 420 Words
    • 2 Pages

    Move the compass along a semicircular path above the coil until you’ve put it on the opposite side of the coil. Describe what happens to the compass needle.…

    • 420 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    A. If the North Pole exist B. The N-pole of the coil C. The N-S poles apply D. All of the above…

    • 692 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Saturable-Core Reactor

    • 590 Words
    • 3 Pages

    Typical input voltage and current waveforms for a saturable core reactor power supply, with the core partially saturated, is shown in the oscilloscope picture of Fig. 2b. When the core is fully saturated the current waveform is near sinusoidal. The inherent series reactance of a saturable reactor causes a phase shift between the voltage and current. Fig. 2b shows the voltage leading the current. Due to the series reactance, the best…

    • 590 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Within this experiment we recorded that the theoretical capacitance of 0.470 is accurate with the capacitor from box C. The LRC circuit is proven to have a voltage accurate with the measured generator voltage because the largest percentage of error , 0.55 % error, is much lower than 5% error.…

    • 260 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    The BENZ LinA Broach for BMT and VDI applications is available in six different models…

    • 654 Words
    • 2 Pages
    Good Essays
  • Powerful Essays

    physics

    • 1629 Words
    • 7 Pages

    = I ×V cost of electricity = power × time × cost of 1 kilowatt-hour power = energy used time taken efficiency = P= (useful energy transferred by the device) × 100% p (total energy supplied to the device) primary voltage number of turns on primary coil = secondary voltage number of turns on secondary coil 2 E t Vp Vs = Np…

    • 1629 Words
    • 7 Pages
    Powerful Essays
  • Powerful Essays

    Abstract-At transonic speeds an aerofoil will have flow accelerate onwards from the leading edge to sonic speeds and produce a shockwave over the surface of its body. One factor that determines the shockwave location is the flow speed. However, the shape of an aerofoil also has an influence. The experiment conducted compared Mach flow over a supercritical aerofoil (flattened upper surface) and a naca0012 aerofoil (symmetrical). Despite discrepancies, the experiment confirmed the aerodynamic performance of a supercritical aerofoil being superior to a conventional aerofoil. A comparison of the graphical distributions demonstrates the more even pressure distribution on a supercritical aerofoil and a longer delay in shockwave formation. All of which, reflects the theory.…

    • 2624 Words
    • 11 Pages
    Powerful Essays
  • Good Essays

    Electromagnetic vibrating feeder in the core and the size of the air gap between the armature directly affect the normal operation of the feeder , such as improper adjustment , the light so that the current increase, the amplitude is reduced and can not operate normally , severe collisions will produce core cause damage to the core and coil. Therefore, regular inspection and adjustment of the air gap is an important condition to ensure operation .…

    • 499 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    HIGH VOLTAGE

    • 284 Words
    • 4 Pages

    same center point. The inner electrode has a radius r1 whereas the outer electrode, r2. The…

    • 284 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    voltage and current law

    • 631 Words
    • 3 Pages

    b. Place on the circuit shown in Fig.1 the proper measurement devices to indicate all the…

    • 631 Words
    • 3 Pages
    Good Essays