Preview

Reduction Of Camphor To Isoborneol Hend Altajjar

Satisfactory Essays
Open Document
Open Document
433 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Reduction Of Camphor To Isoborneol Hend Altajjar
Title : reduction of camphor to isoborneol Hend Altajjar
Date: 01\30\2015 disk no. 116 lab report

experiment procedure

I scaled up 0.120 g of camphor , the I added 1.0 ml of methanol in a 10-ml Erlenmeyer flask. I stirred with a glass stirring rod until the camphor has dissolved.
Then I added 0.10 g of sodium borohydride, after I started to boil the contents of the flask on a warm hot plate for 7 minutes then I left the reaction to calm.
I added 3.5ml of ice-cold water, then I collected the white solid by filtering , I transferred the solid to a 10-ml Erlenmeyer flask then I added 4ml of methylene chloride to dissolve the product, then dried the solution over granular anhydrous sodium sulfate.
…show more content…
Calculation

camphor(MW= 152.23 g/mol)
Amount used = 1.00g
(0.120g)(1mol / 152.23g) = 0.000788 mol

Theoretical Yield
Isoborneol
(0.000788mol)(154.249g/mol product)
= 0.12159 g methyl

You May Also Find These Documents Helpful

  • Good Essays

    Oil Of Wintergreen

    • 516 Words
    • 3 Pages

    The solution then gets foggy/cloudy and white snowlike precipitate is floating within the solution. Heat is added along with a stir bar. The stir bar starts stirring at minute 7. It begins to dissolve the white powder as it spins. At minute 26 the solution becomes clear with barely any flakes left. Sulfuric acid is then added and white flakes are formed. More acid is added until the pH paper turns red. The round bottom is filled with white precipitate. The precipitate is put onto a hirsh funnel that uses vacuum filtration to isolate the precipitate. The product is then added to a beaker with D.I water and heated. It’s put through the hirsh funnel . 3.68 grams of salicylic acid is recovered. The melting point is tested to compare to a perfect sample. The melting point is 146C0. The product is dried and added to a beaker with D.I. water and 10mL of acetic anhydride and 20 drops of concentrated sulfuric acid. This product is chilled to produce crystals. Its then filtered using a hirsh filter using vacuum filtration. Recrystallized and filtered one last time. The product is now acetylsalicylic acid…

    • 516 Words
    • 3 Pages
    Good Essays
  • Good Essays

    post lab of cucl2

    • 732 Words
    • 3 Pages

    3. Add approximately 50 mL of tap water to the crystals in the beaker. Stir the mixture with a glass stirring rod until all of the crystals are dissolved.…

    • 732 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Dissolve the solid in exactly 4 mL tert-butyl methyl ether of. Add exactly 2 mL of water, cap the tube and shake. Let the mixture stand until two layers are formed. Remove the aqueous layer. Wash the organic layer two more times with exactly 2 mL of water (each time). After the final wash, dry the organic layer with calcium chloride pellets. Remove the ether with a pipette and filter through a funnel plugged with cotton into a pre-weighed 50 mL beaker including a boiling chip. Wash the pellets with a full pipette of ether. Remove the ether with a pipette and filter through the funnel plugged with cotton into the 50 mL beaker. Evaporate off the ether in the hood on a hot plate under low heat. When the beaker has cooled to room temperature, weigh the…

    • 2981 Words
    • 12 Pages
    Powerful Essays
  • Satisfactory Essays

    paper1

    • 374 Words
    • 2 Pages

    Place 50g of solid NaCl in a 400mL beaker and add just enough water to dissolve the salt.…

    • 374 Words
    • 2 Pages
    Satisfactory Essays
  • Better Essays

    Formal Lab 3

    • 1114 Words
    • 12 Pages

    the second week of this lab we will use sodium borohydride to reduce (Mechanism: Figure 7) the…

    • 1114 Words
    • 12 Pages
    Better Essays
  • Powerful Essays

    Add 6 mL of 2-methylcyclohexanol, 5 mL of 85% phosphoric acid and a boiling stone to a 25 mL round bottom flask.…

    • 896 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    9) Then 20mL of distilled water and 3-4 drops of bromcresol green was added into the flask containing 5mL water and 5mL borax solution.…

    • 1437 Words
    • 6 Pages
    Good Essays
  • Good Essays

    after put 50 ml of distilled water to the beaker. Stir it to dissolve the solid material. Then to…

    • 612 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Stir the solution gently, and then add ~ 1 mL of sodium thiosulfate (10% w/w). The solution will turn a cloudy, grayish yellow. Acidify the solution with 3.2 M HCl, using pH paper to check the acidity of the solution (it will take approximately 0.6 mL of added HCl). Gently evaporate any excess ethanol. (Apply gentle heat only if necessary). Cool in an ice bath for…

    • 961 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    3. Transfer the KHP into the Erlenmeyer flask using the funnel, then use the spray bottle to get any remaining solid into the flask.…

    • 2054 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    After a week, solution was poured from the crystals. Methanol (10 ml) was then added to the flask containing the crystals and. the accumulation of the crystals was broken down with a stirring rod.…

    • 986 Words
    • 4 Pages
    Good Essays
  • Satisfactory Essays

    Add 5 mL of 6 M HCl to each beaker. Stir until the solid salt has dissolved. If the solid remains after stirring add 6 M HCl in 2 mL increments until solid is dissolved.…

    • 691 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    We then heated our solutions to boiling on a hot plate. Once the mixture became pasty, we took it off the plate and let it cool. We added about 50 mL of a saturated NaCl solution and ice while continuing to stir. After this, we filtered the soap out using suction filtration…

    • 1458 Words
    • 6 Pages
    Good Essays
  • Powerful Essays

    3. Add 18 ml of distilled water and stir the misture with a glass stirring rod to dissolve the sample.…

    • 818 Words
    • 5 Pages
    Powerful Essays
  • Satisfactory Essays

    Tongkat Ali

    • 305 Words
    • 2 Pages

    In Malaysia, the consumption of chocolate is still low even though there is an increament from year to year. In 1985, the consumption of chocolate was around 0.245 kg per person and this increased to 0.675 kg per person in 1992. The consumption of chocolate is always related to children. However, the consumption among adults are low. This could be due to the misconception of chocolate itself. Chocolate is always associated with obesity, tooth decay, hyperactive, pimples and other negative effects.…

    • 305 Words
    • 2 Pages
    Satisfactory Essays