Preview

Resistivity

Powerful Essays
Open Document
Open Document
2813 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Resistivity
Episode 112: Resistivity

In this episode, students learn how and why the resistance of a wire depends on the wire’s dimensions. They learn the definition of resistivity and use it in calculations.

Summary
Discussion: Variation of resistance with length and area. (5 minutes)
Student experiment: Variation of resistance with length and area. (30 minutes)
Discussion: Variation of resistance with length and area. (10 minutes)
Student experiment: Measurement of resistivity. (30 minutes)
Student questions: Using these ideas. (30 minutes)

Discussion:
Variation of resistance with length and area
The analogy to water flow will be useful here - ask them how they think the flow rate will be affected if you increase the cross-sectional area or length of the pipe along which the water has to flow. This should lead to two predictions about the resistance of a wire: resistance increases with length resistance decreases with diameter or cross-sectional area
It will be worth reminding them that doubling the diameter quadruples the cross-sectional area; many students get confused about the distinction and expect a wire of double diameter to have half the resistance.

Student experiment:
Variation of resistance with length and area
You could ask them to do one or both of the following experiments. Both reinforce the idea that resistance depends on material dimensions:

TAP 112-1: How the dimensions of a conductor affect its resistance
TAP 112-2: Introduction to resistivity using conducting paper

Discussion:
Variation of resistance with length and area
Follow up with some theory suggesting:
Resistance is proportional to length l
Resistance is inversely proportional to cross-sectional area A
R= constant x length / cross-section area
The constant is a property of the material used - its resistivity  R = l / A
The units of resistivity can be derived from the equation: m.
Emphasise that this is ‘ohm metre’, not ‘ohm per metre’.
Discuss

You May Also Find These Documents Helpful

  • Powerful Essays

    4. A. Ohm’s law states that the current in an electrical circuit varies directly as the voltage and inversely as the resistance.…

    • 852 Words
    • 4 Pages
    Powerful Essays
  • Good Essays

    Brandico Barr Module 3

    • 608 Words
    • 3 Pages

    4. Define resistance and describe what would happen to a light bulb if the voltage increased but the resistance stayed the same. Resistance is the opposition to current flow. In a light bulb if the r stayed the same and the v increased then the current would increase causing the light bulb to become brighter.…

    • 608 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Hai by the Water 345

    • 634 Words
    • 3 Pages

    Suppose an electrical wire is replaced with one having every linear dimension doubled (i.e. the length and radius have twice their original values). Does the wire now have (a) more resistance than before, (b) less resistance, or (c) the same resistance?…

    • 634 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    The formula used to calculate the resistance (R) of a conductor, given its length (l), cross sectional area a. and the constant of resistivity (p)…

    • 1234 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    Hypothesis: I believe that a filament bulb will have an increasing resistance depending upon the current passing through it.…

    • 447 Words
    • 4 Pages
    Satisfactory Essays
  • Good Essays

    Circuits 2014

    • 604 Words
    • 3 Pages

    Using Ohm’s law V = I x R (page 607 in textbook) calculate the resistance of the light bulb. Don’t forget the units! (3 points)…

    • 604 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Circuit 3

    • 721 Words
    • 2 Pages

    4. Define resistance and describe what would happen to a light bulb if the voltage increased but the resistance stayed the same. Resistance is what slows the flow of electrons in a circuit. As described in the previous question, Ohm’s law states current=voltage/resistance. If we keep resistance the same and increase the force at which the…

    • 721 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    I have decided to do a preliminary investigation. This preliminary will help plan my main experiment. I will choose 3 lengths, 10cm, 50cm and 100cm. These lengths are reliable as they don't jump lengths too much. One small, medium and large length. Here I will use a simple circuit and study the results, to see they are reliable. This investigation will mainly show the accuracy and how reliable my main investigation is, changing anything that is unreliable and needs corrected. I have learned that it is important to use a multimeter because it shows an accurate digital reading of the resistance and I don't have to work out the resistance manually which can give me a fairer test due to possible mistakes with calculations. It will also cut down the amount of components in the experiment which will make the experiment more reliable as less resistance will be caused from the components rather than the wire. It is also very important to keep the most important variable, current the same throughout the whole investigation. The heat in the wire from the current can cause the wire to affect my results as the ions gain kinetic energy causing them to have a higher collision rate. The multimeter should be a solution to this, as it uses a very small current thus not affecting the temperature in the circuit. The advantage of using the same apparatus consistently is that I will avoid having differences in the results by way of inaccuracies in the measuring equipment, resistance…

    • 334 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    One way in which, the resistance shaped the…

    • 192 Words
    • 1 Page
    Satisfactory Essays
  • Powerful Essays

    Resistance of a Wire

    • 2028 Words
    • 9 Pages

    The Width – when the wire is very thin its very hard to go through, you can compare it to a person going through a big, or little door, the thinner the door (wire) the harder it will be to go through it. With other words the thinner the wire gets the higher the resistance.…

    • 2028 Words
    • 9 Pages
    Powerful Essays
  • Good Essays

    Wire Coursework

    • 591 Words
    • 3 Pages

    In this piece of Coursework I am going to investigate the resistance in a piece of wire.…

    • 591 Words
    • 3 Pages
    Good Essays
  • Powerful Essays

    Conductivity

    • 1845 Words
    • 8 Pages

    There are three main sections to this module: terrestrial coordinates, celestial equatorial coordinates, and understanding how the ecliptic is related to seasons on the Earth. Each of these sections has its own simulator(s). The background material necessary to utilize these tools is contained in each section.…

    • 1845 Words
    • 8 Pages
    Powerful Essays
  • Powerful Essays

    For this piece of coursework I have been asked to investigate into the resistance of wires when the length is changed.…

    • 1394 Words
    • 6 Pages
    Powerful Essays
  • Better Essays

    Wire Coursework

    • 1909 Words
    • 8 Pages

    Due to the strong correlation of the results, the explanation of this is unlikely to be the method used to obtain the results. The more likely explanation would be that the first wire was actually of a larger diameter than the second one. Obviously this is a rather important oversight and this will be discussed more in the Evaluation section. The reason why this is the likely explanation is because resistance is known to be inversely proportional to the cross-sectional area, i.e. if you increase the cross-sectional area (by increasing the diameter) then you decrease the resistance. This is because a wider wire means less likelihood of the free electrons having collisions and losing…

    • 1909 Words
    • 8 Pages
    Better Essays
  • Satisfactory Essays

    Passive Resistance

    • 289 Words
    • 2 Pages

    music was important to the slaves as a form of passive resistance because they could communicate, give each other signs of escape/runaway and keep their spirits up. music was very meaningful to the slaves in the past.…

    • 289 Words
    • 2 Pages
    Satisfactory Essays