Preview

Selab Chemistry Lab

Satisfactory Essays
Open Document
Open Document
263 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Selab Chemistry Lab
Name: Aaron Banks Section: Thursday PRELAB: A MODEL FOR CIRCUITS I: ELECTRIC CURRENT 1. What do you predict for the rankings of the brightness of bulbs A, B, and C in Figure 2-1? A>B>C A being the brightest

2. How do you predict that changing the direction of the current by reversing the connections to the battery in Figure 2-1 would change the rankings in (1)? I don’t think it will change at all. The brightness should be the same in diagram b and diagram a it should also stay the same.

3. How will you compare the currents in the circuits in Figure 2-1 experimentally? What equipment will you use? Take the current left of the bulb and right of the bulb in figure a and take the current left and right of each bulb

You May Also Find These Documents Helpful

  • Satisfactory Essays

    ECT122 W3 ILab 2

    • 279 Words
    • 2 Pages

    1. Using the circuit below, calculate the following values. On the circuit drawing, indicate the polarities for each voltage and show the current direction.…

    • 279 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    ECT122 Wk5 ILab 3

    • 372 Words
    • 2 Pages

    1. Determine the load voltage by deriving an equivalent circuit for the circuit below. Reduce the R1, R2, and R3 combination to a single equivalent resistance. Also, reduce R4 and RL1 to a single resistance.…

    • 372 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Nt1310 Week 4 Lab Report

    • 925 Words
    • 4 Pages

    24. Calculate the magnitude and phase angle of the circuit impedance shown in Figure 11.39b.…

    • 925 Words
    • 4 Pages
    Satisfactory Essays
  • Powerful Essays

    Nt1310 Unit 5 Activity 2

    • 2141 Words
    • 9 Pages

    The concepts behind the direct relationship of battery cells and compass deflection are the same concepts that support the direct relationship of voltage difference and current included in Ohm’s Law. When we began gather data using Ohm’s Laws, the trend of current increasing as voltage increases made sense because Unit 2 Activity 3 taught me that flow rate increases when the number of battery cells increases.…

    • 2141 Words
    • 9 Pages
    Powerful Essays
  • Satisfactory Essays

    ECT122 Wk7 Assignment

    • 743 Words
    • 3 Pages

    15. Calculate the rms values of load voltages and current for the circuit shown in Figure 9.49a.…

    • 743 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Brandico Barr Module 3

    • 608 Words
    • 3 Pages

    2. Compare and contrast a series and parallel circuit. Give at least one way that they are alike and one way that they are different. In a series circuit, electrons travel only one path, while in a parallel circuit there is more than one path the electrons can follow. Both circuits have a current which can flow.…

    • 608 Words
    • 3 Pages
    Good Essays
  • Good Essays

    Chemistry Lab 4-4

    • 1627 Words
    • 7 Pages

    100 mL of water is already in the calorimeter. Use the density of water at 25°C (0.998 g/mL) to…

    • 1627 Words
    • 7 Pages
    Good Essays
  • Satisfactory Essays

    Chemistry Lab Questions

    • 941 Words
    • 4 Pages

    3. List whether each of the following substances was positive or negative for starch, as indicated by using iodine. (7 points)…

    • 941 Words
    • 4 Pages
    Satisfactory Essays
  • Satisfactory Essays

    ECT122 Wk6 Assignment

    • 444 Words
    • 2 Pages

    18. Determine the value of load power (PL) for the circuit shown in Figure 6.48b.…

    • 444 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    1. Incandescent light bulbs have a very thin filament that glows when hot. Thin filaments have very / low resistance.…

    • 350 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Gap Band

    • 2343 Words
    • 10 Pages

    1. Based on your observations in Experiments 1 and 2, prepare a single table listing an approximate band gap energy, Eg compared to composition of the LEDs, as well as the voltage across each LED. Recall that Eg = hc/λ.…

    • 2343 Words
    • 10 Pages
    Powerful Essays
  • Satisfactory Essays

    3. Explain the relationship between the voltage output of the power supply and the voltage across each diode in the parallel circuit. Explain the relationship between the current output of the power supply and the current through each diode in the parallel circuit. Explain how your data support the relationship observed.…

    • 188 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    The Working of Wires

    • 2582 Words
    • 11 Pages

    INTRODUCTION Electricity is usually invisible. Except for lightning and sparks, you never see it in daily life. However, light bulbs and a magnetic compass can show you when something electrical is happening. By observing their behavior and making a few assumptions, you can begin forming ideas about electricity. This type of thinking is called “building a model”. INVESTIGATION ONE: WHAT IS NEEDED TO LIGHT A BULB? 1.1 Activity: Lighting bulbs in a loop Insert three D-cells into the battery holder (as in Figure 1.1), and insert two ROUND bulbs (not long bulbs) into a pair of sockets. Use three wires to connect the sockets to each other and to the two “terminals” of the battery holder: 1) the spring inside the case near the red spot, and 2) the metal post on the outside of the case near the blue spot. The bulbs should light and be of similar brightness. The battery, bulbs and wires now form a “closed loop”.…

    • 2582 Words
    • 11 Pages
    Good Essays
  • Good Essays

    Informative Speech

    • 910 Words
    • 4 Pages

    Turning on a light is simple; however the creation of one is and was difficult back in the 1800’s.…

    • 910 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Illumination Notes

    • 2740 Words
    • 11 Pages

    Simply get polar plot for luminaire and work out the illumination on surface for a given lamp. Called the point illumination method.…

    • 2740 Words
    • 11 Pages
    Good Essays