Top-Rated Free Essay
Preview

Simple Distillation Report 2

Powerful Essays
684 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Simple Distillation Report 2
CHE 317 "Simple Distillation"
Interpretation of Results and the Report
In addition to learning the technique of performing a distillation, you have had the opportunity to observe at first hand the behavior of a reasonably pure compound in the distillation process. You also measured quantities (temperatures) whose magnitudes you did not know beforehand.
Title (be specific)
Your Name
Date
Course Number (CHE 317-01)
Introduction (give a brief statement about what a simple distillation is, what it is used for and an explanation of how it works to separate compounds. Then state concisely what is to be done in this experiment. Do not draw the apparatus!
Do not state a "purpose".)
Data: (a table of the data collected, word processed) (a graph of the data using the computer)
Results (a paragraph describing any observations or conclusions.
Your report should include the following:
1. A brief introductory discussion, in your own words, of the physical principles involved in the distillation of a liquid.
2. The Experimental section, in which you describe in your own words the procedure you have carried out. A tabulation of the volume and temperature measurements must be presented. The atmospheric pressure at the time of the distillation, if known, should be noted as well.
3. A brief Discussion of Results, excluding details of experimental procedures. This part provides the interpretation of the accumulated data and other pertinent observations. A graph of vapor temperature vs. distillate volume would be most helpful in presenting the conclusions to be drawn from the experimental results. An indication of the relative amount of forerun, if any, and the corresponding temperature range over which it was collected should be cited. The boiling range of the distillate collected in a single container must be reported. As an example, consider the following distillation in which no forerun was collected separately. The temperature at which the first drop was collected was 110oC. The distillation was stopped when the still-head temperature registered 122oC. The boiling range of the distillate in that case was therefore 110-122oC. (Note that the boiling range has a beginning value and an end value. Thus, the range in the example is not 122o, but is 110-122oC.) If 5 mL of forerun were collected first, and the main body of distillate (32mL) then collected from 120-122oC, the 120-122oC range is the boiling range of the major portion of the liquid. Some comment on the appearance of the liquid before and after distillation is in order, as is any other significant observation.
Note: It is not considered good form to use the first person pronouns I or we in chemistry reports. Instead of “I added
30 mL”, write instead “Thirty mL was added.” (Use passive voice)
Your lab report should follow the format and consist of the following:
4. Answer the following questions:
a) In a short paragraph, describe how simple distillation separates two compounds with different boiling points.
b) If the thermometer is placed above the outlet to the condenser, will the temperature measured be correct? If not, will it be higher or lower than the actual vapor temperature?
c) What are boiling stones and why are they added?
d) Describe the observations that one would make during the simple distillation of an "impure" substance.
e) What happens to the still head temperature during the simple distillation of a pure substance.
f) In a simple distillation, you measure a boiling range that is 110-121 degrees; How pure do you think the liquid sample is? Explain
g) You have just completed a simple distillation and have made observations of the temperature as the distillate is collected. How would you know whether your distillation was successful and that the distillate is reasonably pure?
Attach the carbon copies from your notebook.

© Dr. Noel Sturm 2009

Grading rubric as it pertains to CHE 317 Lab.

Section of Lab report Possible Points Points Received

Introduction 2

Data

6 Observations

Calculations

2 Graphs

Results 6 Discussion

Questions 4

Removed of Safety 0 -­‐10 pts Goggles

Carbon Copy with 0 -­‐3 pts Signature

Grading Rubric 0 -­‐3 pts

Comments

You May Also Find These Documents Helpful

  • Satisfactory Essays

    bsn 412

    • 362 Words
    • 2 Pages

    May be organised in relation to each of the individual aims or questions, and identify specific methods of experimentation for those…

    • 362 Words
    • 2 Pages
    Satisfactory Essays
  • Powerful Essays

    Objective: The main goal of this lab is to learn how separation of binary liquid mixtures is performed. Especially when the two liquids have boiling points varying by about 30° C. Hexane can be separated from toluene in this experiment because of the difference in their boiling points. Since toluene has a higher boiling point, it will left at the bottom while the hexane starts to boil out and collect in the Hickman still. GC measurements help us in determining how accurate our data is by making a graph of the amount of hexane and toluene in each fraction. Also this lab gives experience with semi-micro distillation in order for experiments in the future that might need this purification setup.…

    • 1041 Words
    • 5 Pages
    Powerful Essays
  • Satisfactory Essays

    Molar Mass Lab

    • 478 Words
    • 2 Pages

    Filled 600 mL beaker with ice, took temperature until it got to -10 c. The next step was to take 1 test tube with water placed in water bath, freezing point of distilled water -0.0 c.…

    • 478 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Ms Hillyer

    • 259 Words
    • 2 Pages

    < Include information that the reader would need to repeat your experimental procedure. Do not include any observations or results in this section?…

    • 259 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    Distillation Lab Report

    • 418 Words
    • 2 Pages

    Conclusion: During this lab I learn how to do simple and fractional distillation. Although the group I worked with only did simple distillation, I carefully observed how the group that did the fractional distillation. We collected all the results, to have a more precise range on what the results were. One way to produce an error in this process would have been if our procedures were done wrong or reversed or if we placed the compounds in a improper…

    • 418 Words
    • 2 Pages
    Good Essays
  • Satisfactory Essays

    Chem Lab 2 Report

    • 942 Words
    • 9 Pages

    Procedure: In the experiment, I use devices such as a ruler, beakers, flasks, a scale and cylinders to measure the values of each object and liquid.…

    • 942 Words
    • 9 Pages
    Satisfactory Essays
  • Good Essays

    The distillation procedure is initiated by gradually heating the mixture until it reaches the temperature of the liquid with the lower boiling point. This liquid then turns into a vapor and leaves to mixture and is collected by the set up apparatus. In fractional distillation a vigreux column is used. This provides for surface area for condensation to occur. At each condensation event the vapor is enriched in the low boiling point component and the liquid is enriched in the high boiling point component. The surfaces where condensation occurs are called theoretical plates. Separation is more efficient when there are more theoretical plates. Therefore, fractional distillation is more efficient in separating than simple distillation. Another new technique was gas chromatography. Gas chromatography is used to separate volatile components of a mixture. First, a small amount is draw up into a syringe and the contents of the syringe are placed into a hot injector pot of the gas chromatograph. The components of the mixture evaporate into the gas phase inside the injector. A carrier gas flows through the injected and pushed the…

    • 395 Words
    • 2 Pages
    Good Essays
  • Good Essays

    2) In a clear and organized manner, outline your experimental design and describe the procedures you…

    • 681 Words
    • 3 Pages
    Good Essays
  • Good Essays

    LAB 5

    • 31937 Words
    • 128 Pages

    The experiments in this manual have been and may be conducted in a regular formal laboratory…

    • 31937 Words
    • 128 Pages
    Good Essays
  • Satisfactory Essays

    < Include information that the reader would need to repeat your experimental procedure. Do not include any observations or results in this section>…

    • 552 Words
    • 3 Pages
    Satisfactory Essays
  • Satisfactory Essays

    Unknown liquid

    • 264 Words
    • 2 Pages

    III. Procedure: 1.We massed an empty 10mL graduated cylinder to the nearest .01g. 2.Then, we filled the graduated cylinder with 4.0-5.0 mL of distilled water, 3.massed it to the nearest 0.1 ml and 4. recorded the data. Then to determine the density of the unknown liquid; we repeated the steps.…

    • 264 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    A. Abstract: This appears first in the paper, but it is the last section written. In the Abstract: (1) state the major objective(s) and scope of the experiment, (2) briefly describe the methodology used, (3) summarize the results, and (4) state the major conclusions. (3 points)…

    • 1226 Words
    • 5 Pages
    Good Essays
  • Satisfactory Essays

    In this lab you will apply your knowledge of the scientific method in a laboratory setting. You will also demonstrate the use of experimental terminology and design.…

    • 559 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    Distillation

    • 894 Words
    • 4 Pages

    • When spirits are distilled the original liquid has already been fermented and is an alcoholic ‘wine’ or wash. After the ‘wine’ or wash has been converted into vapor and then condensed back into a liquid it is called a distillate. Impurities are left behind in the original container.…

    • 894 Words
    • 4 Pages
    Good Essays
  • Good Essays

    ASSIGNMENT INTRO CPE 420

    • 1118 Words
    • 5 Pages

    Figure 1.1: Batch distillation column with three receivers for products (main cut) and three receivers for mixtures (off cut).…

    • 1118 Words
    • 5 Pages
    Good Essays