Preview

Thin Layer Chromatography

Good Essays
Open Document
Open Document
564 Words
Grammar
Grammar
Plagiarism
Plagiarism
Writing
Writing
Score
Score
Thin Layer Chromatography
Discussion
Using the Thin Layer Chromatography experiment, caffeine was found to be the most polar due to the fact that it stayed closer to the stationary phase. Caffeine contains four amine groups that are extremely polar as a result of the hydrogen bond and amide functional group. Acetaminophen was found to be the second most polar analgesic drug tested. Acetaminophen contains a polar alcohol group on one side and amide group on the other but also includes non-polar functional groups that consisted of the benzene ring and methyl group. Acetylsalicylic acid low polarity results from only containing a carboxylic acid and ester and the presence of alkenes in the benzene ring. Ibuprofen was the least polar out of all analgesic drugs because it only contains one carboxylic acid and non-polar functional groups. The behavior of these compounds in function of their structure and polarity were inversely associated. The TLC plate is made up of highly polar silica gel. Caffeine showed the smallest Rf value of (.278), shadowed by acetaminophen Rf value of .5556 cm, followed by acetylsalicylic acid’s Rf value of (.667), and then the largest Rf value that ibuprofen had of (.722). The polar molecules of the analgesic drugs were attracted to the highly polar silica gel, which explains the low retention rate of caffeine that and the high retention rate of the ibuprofen that is the least non-polar. The eluent used for this experiment was a 50:50 mixture of ethanol and methyl chloride due to both liquids polarity. Caffeine and acetaminophen are very polar and the table itself is extremely polar so therefore needs an eluent that is reasonably polar or the experiment would not have the same result. The substances would not be able to move up the plate if the eluent was not as polar as the silica gel because of the abundant attraction to the plate. For this purpose, ethanol and methyl chloride were chosen. The mixture had to be a 50:50 because if the liquids were unequally

You May Also Find These Documents Helpful

  • Good Essays

    The purpose of this experiment was to create and obtain pure acetaminophen. p-aminophenol and acetic anhydride were used to create acetaminophen and acetic acid. The acetic acid mixed with acetaminophen created an impure sample, which was purified through the addition of a water/methanol solution. The percent recovery of acetaminophen from the impure sample to the pure sample was 76%. The melting point of the pure sample was 167C - 169C.…

    • 860 Words
    • 4 Pages
    Good Essays
  • Powerful Essays

    Aspirin, Caffeine and Salicylamide were extracted from an over-the-counter pain reliever (BC Powder). These components were separated by manipulating their solubilities by adjusting the acidity and basicity of the solution. By doing this, the three components were forced into conjugate acid (or base) forms, causing selective solubility in either an aqueous or organic solvent. These layers were then separated by use of a separation funnel. Once separated, the components extracted were characterized by measuring the melting point and performing a TLC analysis. Also, the recovered aspirin from the first part of the experiment was recrystallized and compared to that of the isolated aspirin.…

    • 1653 Words
    • 7 Pages
    Powerful Essays
  • Good Essays

    The purpose of this experiment is to investigate the composition of a simulated pharmaceutical preparation Panacetin, a proposed type of pain-killer. Panacetin is typically made up of sucrose, aspirin, and acetaminophen, but the third component in this experiment is unknown. The unknown component is suspected to be a chemical relative of acetaminophen, either acetanilide or phenacetin. Using techniques such as extraction, evaporation, and filtration, the three components will be isolated based on their solubilities and acid-base properties. The percent composition of Panacetin will also be deduced based on the masses of the three dried components; this is done to verify the composition attained is consistent with those listed on the preparations label. As a result of this investigation, my teammates and I allowed the Panacetin to undergo gravity filtration and separation techniques in order to identify whether there are any discrepancies in the components of the Panacetin. Furthermore, recrystallization and purification methods were used to determine if the unknown substance were similar in properties to either of the suspected unknown substances by comparing factors such as melting points to the chemical properties of phenactin and acetanilide. The results were as expected, based on the molecular weights and ratios of each separated chemicals, as well as the boiling point of the unknown it was determined that these ranges were close enough to indicate that the label is reasonably accurate in its composition. To add on however the identity of the unknown component differed from what the label indicated. In the end, the percentage composition attained based on our observations and yield confirmed that indeed the chemical composition of Panacetin were as indicated on the preparations label. The identity of the unknown component however suggested that the preparation did not contain acetaminophen as indicated, but instead was consistent with the chemical properties…

    • 305 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Pre-Lab: Analgesic drugs are known for reducing pain, while antiseptic drugs reduce symptoms such as fevers and swelling. However, some of these drugs can reduce both illnesses. To obtain a pure compound in these drugs, the scientist needs to separate the desired compound by taking advantage of the different physical and chemical properties. Such as; different boiling points, melting points and their solubility properties. To do this a chemist can also asses the differences between acidic and basic substances when they are added to water soluble mixtures. Within this current experiment I will asses the pharmaceutical preparation of Panacetin, by using it 's solubility along with other organic molecules. We know that Panacetin is made up of sucrose, aspirin and some other unknown substance. We know the substance has to be Phenacetin or Acetanilide. To help solidify our reasoning, we need a % recovery of 8-12% sucrose, 35-45% aspirin and 45-55% unknown.…

    • 1948 Words
    • 56 Pages
    Good Essays
  • Better Essays

    Acetaminophen Kbr

    • 1839 Words
    • 8 Pages

    The retention time for Ibuprofen is 12.951 minutes, which was used to pick the correct peak that relates to Ibuprofen’s Mass Spectrometry spectra. The molecular mass of Ibuprofen from our MS spectrum is 206.0 g/mol. We continued the same process of determining the structure of Ibuprofen includes analyzing and subtracting the stable ion fragment peaks by the parent ion peak. The fragment peaks from our Ibuprofen spectrum are 161.2 g/mol, 119.2 g/mol, 107.2 g/mol, 91.2 g/mol and 41.2 g/mol. This MS spectrum required a different approach to analyzing the stable ion fragments.…

    • 1839 Words
    • 8 Pages
    Better Essays
  • Good Essays

    Tlc questions

    • 567 Words
    • 3 Pages

    8. A 50/50 mixture of dichloromethane and ethanol was added to the crushed analgesic tablets to fully dissolve the tablets because the whole tablet will not dissolve as it contained not only the analgesic, but also binders, buffering agents and other components that would not make the tablet to fully dissolve in just a polar solvent.…

    • 567 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    Acetaminophen is a common analgesic used to treat mild pain. We synthesized acetaminophen by reacting p-aminophenol and acetic anhydride. The amine group on the p-aminophenol reacted with the center oxygen atom on the acetic anhydride to form an amide. We reacted 0.210g of p-aminophenol with 0.240ml of acetic anhydride in the presence of heat, and then cooled the solution in an ice bath until crystals formed. The solid acetaminophen was filtered from the solution and then subjected to a recrystallization using a 50:50 water-ethanol solvent. 0.1484g of crude acetaminophen was measured and after purification 0.0669g of pure acetaminophen was collected. A percent yield of 23% was calculated from our theoretical and actual yield. The melting point…

    • 142 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    Hence, from least to greatest relative polarity, the order of the compounds are as such: ibuprofen, aspirin, acetaminophen, caffeine. According to their molecular structures, caffeine is the most polar because of the unpaired electrons on the nitrogens and the unpaired electrons on the oxygens. In other words, one side of the molecule has two amides and is more negatively charged due to the lone pairs of electrons on the two nitrogens and the two oxygen (6 pairs of lone electrons), while the other side has 1 amine and is less negatively charged. On the other hand, aspirin is only slightly polar in comparison to the other compounds. This is because it has an ester group and carboxylic acid group; however, only the oxygen in the carboxylic acid has lone pairs of electrons that can form bonds.…

    • 818 Words
    • 4 Pages
    Good Essays
  • Good Essays

    Aspirin Research Paper

    • 1199 Words
    • 5 Pages

    Aspirin has a pKa of 3.49 and a melting point of 138-140 degrees Celsius. Aspirin molecule’s are insoluble in water that is why it must be sold in a solid form, there are no liquid forms of aspirin available. Aspirin is ionised in the stomach. Aspirin is easily hydrolysed as…

    • 1199 Words
    • 5 Pages
    Good Essays
  • Good Essays

    Tlc Lab

    • 515 Words
    • 3 Pages

    It is important to note that acetic acid is the non-polar component of the experiment. On the other hand, the stationary phase corresponded to the Silicon on the TLC plate. From the dipole in Silicon and Oxygen bonds, this is regarded as the polar component of the experiment. Compared to the mobile phase, the stationary phase results in the polar functional groups to be a stronger attractant. As a result, the most polar functional groups will travel up less the TLC plate. Due to the non-polar compounds not sticking to the stationary phase as strongly as the polar compounds do, non-polar compounds should have a larger Rf value than polar compounds. As previously stated, the least to most polar is Ibuprofen, Acetylsalicylic Acid, Acetaminophen, and Caffeine respectively. This shows that ideally, Caffeine has the lowest Rf value while Ibuprofen should have the largest Rf value. In the Observations section, we calculated that Ibuprofen’s Rf value is .81, Acetylsalicylic Acid’s Rf value is .64, Acetaminophen’s Rf value is .46, and Caffeine’s Rf value is .10. This illustrates that the Rf values trend match the the four analgesics’ polarity…

    • 515 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    I added approximately a quarter of a tablet of acetaminophen, aspirin, caffeine, ibuprofen, salicylamide, and the unknown (#19) to separate test tubes containing 2.5mL of dichloromethane. I noticed that my unknown was a coated tablet. Each test tube was swirled until the greatest amount of each solid was dissolved. Each solution was spotted along a labeled starting line on the silica gel TLC plate. The TLC plate was put into a developing chamber containing 200:1 acetic acid and allowed to developed until the solvent reached almost to the top of the TLC plate, which took about 10 minutes.…

    • 356 Words
    • 2 Pages
    Satisfactory Essays
  • Good Essays

    paper chromatography

    • 526 Words
    • 3 Pages

    Tryptophane is the largest amino acid. Also two larger amino acids are Alanine and Serine. The largest Rf is Tryptophane. The polarity is like the Serine but the Alanine is nonpolar.…

    • 526 Words
    • 3 Pages
    Good Essays
  • Satisfactory Essays

    The purpose of this laboratory was to determine how different substances have different solubilities in a given solvent. This was accomplished using the method of chromatography. The solubility of each substance was first determined by dropping a drop or two of each on a line drawn 2 inches above the bottom of a piece of paper. Then the paper was lightly bent in order to tape both sides of the paper leaving about a 4 centimeter gap so that the sides of the paper are not touching. The paper was then put into a beaker of a hydrochloric acid, ethanol, and butanol mixture, being sure that the paper does not touch the sides of the beaker, and then topped. After the eluting solution has risen to within two centimeters of the top of the filter paper, the paper was removed from the beaker, dried, and was stained with a staining reagent solution containing potassium ferrocyanide and potassium iodide. This reagent forms colored precipitates or reaction products with many cations, including all of those used in this experiment. The distance of which the spots moved were determined by calculating the Rf value of each substance. The Rf value is determined by following formula:…

    • 307 Words
    • 2 Pages
    Satisfactory Essays
  • Satisfactory Essays

    According to the findings, pH does affect the time ibuprofen needs to start dissolving. The more neutral a solution is, the shorter the ibuprofen takes to dissolve. In chart 2, cup A marks the neutral point. Cup A contains tap water, which we can assume has a pH of around 7. The values to the left of cup A are bases, and all the values to the right of cup A are bases. The strongest of each, cup E and cup B, dissolve ibuprofen the slowest;likewise, the weakest of each, cup C and cup F, dissolve ibuprofen the fastest. Ibuprofen took much longer to dissolve in cup A, tap water, compared to the acid and base to its immediate left and right. In the tables, the times in which ibuprofen dissolved are not always close to each other. There are many…

    • 174 Words
    • 1 Page
    Satisfactory Essays
  • Good Essays

    By examining the functional groups of the analgesic drug components, the relative strength of their polarities can be determined. For example, if a compound contains carboxylic acid, alcohol or amine functional groups, it should be very polar. If a compound contains ketone, aldehyde, ester, amide, or ether functional groups, it should be polar. Lastly, if a compound…

    • 522 Words
    • 3 Pages
    Good Essays