The procedure provided was used with only one change and one correction. The procedure calls for 3 or 4 drops of water to dissolve the dye on the M&M candies but 7 drops were used for each pair of candies because there wasn’t enough water in 4 drops to efficiently dissolve the dyes; the YouTube video for this step from the procedure also showed an application of about 7 drops. The traced solvent front line in this case was not a straight line but a curve with a maximum on 3.2in and minimum on 2.48in
Premium Chemistry Water Laboratory glassware
Abstract To determine the rate law with respect to bleach and blue dye‚ a series of graphic and algebraic manipulations were done on the data obtained in the kinetic trace experiment in order to determine the different components that made up the rate law. Using absorbance spectroscopy to monitor concentration over time‚ rate order of the dye was found to be 1st order through the integrated rate law and through the proportionality method; the order of the bleach was also determined to be 1st order
Premium Rate equation Chemical kinetics Reaction rate
I) INTRODUCTION * Industrial Chemistry deals with the preparation of products from raw materials through the agency of chemical change * Chemistry is important to Industry by: * Regulating manufacturing processes * Quality Control * Research and Development * Sources of raw materials from the natural environment 1) Lithosphere –Earth’s Crust 2) Hydrosphere – Marine and Oceanic Environment 3) Atmosphere – Air 4) Plants – Biosphere * Classification of Natural
Premium Chemical reaction Ideal gas law Chemistry
Spectrophotometry was used in the lab to determine whether non-magnetized zeolite‚ magnetized zeolite‚ or charcoal was the more effective sequestration agent for Procion Red Dye. A calibration curve was created with the known concentrations and the absorbances of the Procion Red Dye dilutions at λmax. The slope of the calibration curve was used to determine the concentration of the analytes. As a result‚ charcoal was shown to be the more effective sequestration agent. Introduction PAHs‚ polycyclic
Premium Polycyclic aromatic hydrocarbon Concentration Solution
characteristics of the flow could be determined. The rock inside the stilling tank are to calm the inflow water so that there will not be any turbulence interfere with the experiment. The water inlet and outlet valve and dye injector utilized to generate the required flow. A dye injection system is installed on top of the header tank so that the pattern of the flow can be visualized. The characteristic of the flow is observed‚ there are laminar‚ transition and turbulent flow. The volume of water
Premium Fluid dynamics Reynolds number Viscosity
Gel Time Blue Dye Red Dye Blue Dye Red Dye 10 sec 1 cm 1cm 1cm 1cm 20 sec 2cm 2cm 1.5cm 2cm 30 sec 2cm 1cm 1.5cm 2.5cm 40 sec 2cm .5cm 1.5cm 2.5cm 50 sec N/C .5cm N/C N/C Molecular Weight Distance Traveled Speed of Diffusion Blue Dye 793g 20.00mm 600mm/hr Red Dye 496g 45.00mm 1350mm/hr Aloe Vera Gel Molecular Weight Distance Traveled Speed of Diffusion Blue Dye 793g 15mm 450mm/hr Red Dye 496g 25mm 750mm/hr 1. The red dye diffused faster
Free Diffusion Molecular diffusion Starch
separate the Red 40 and Blue 1 dyes inside of grape flavored Kool-Aid. It was determined that the 5% isopropanol will remove the Red 40 dye from the stationary phase. The 28% isopropanol will remove the Blue 1 dye from the stationary phase. The more polar molecule is removed with the more polar mobile phase‚ the less polar molecule is removed with the less polar mobile phase. This is where the principle “like dissolves like‚” plays a factor in the separation of the dyes. Both molecules are relatively
Premium Chromatography Solubility Chemical polarity
are actually drinking‚ and how much of that drink is contaminated with dye? In this experiment‚ with the use of a spectrophotometer‚ the amount of concentrated dye in three drinks will be tested. First‚ the dye itself will be examined to see what the optimal wavelength and absorbance will be when created in a serial solution. Red Dye 40 was the prime object that will be studied in this lab because it is one of the most common dyes in every day drinks. Before performing any experiment though‚ it is important
Premium Chemistry Water Acid
component of the dye B) the part of the dye that does not bind. C) the colored portion to the dye. D) part of the dye that is not seen. E) the part of the dye that is not used up.4.Which type of staining method would you use to determine endospore-forming cells from non-endospore-forming cells?A) regular stain B) simple stain C) differential stain D) specialized stain5.An acidic dye is:A) a dye the carries no charge. B) a dye the carries a negative charged chromophore. C) a dye that carries
Free Bacteria Staining Gram staining
Absorption Spectra of Conjugated Dyes 04-21-2103 Introduction: The visible absorption bands or conjugated dye arise from electron transitions involving the electrons in the conjugated and they are free to move along the chain and are not attached to any atom. An example of such a dye is 3‚3-diethyl-thiacyanine iodide. The cation has two resonance forms causing each of the bonds in the conjugated chain to have an order of 1.5 and have a length similar to the C--‐C bond length in benzene
Premium Absorption spectroscopy Electromagnetic radiation Photon