Some metals react with acids while others do not. In this experiment‚ students will perform 2 reactions: aluminum/zinc with excess 6M hydrochloric acid and aluminum-zinc alloy with excess 6M hydrochloric acid. The purpose of this experiment is to determine the atomic mass of each metal and the percent composition of a known mass aluminum-zinc alloy by determining the moles of H2 gas formed. Zn(s) + 2HCl(aq) → ZnCl2(aq) + H2(g) 1 mole of H2(g) is produced for every 1 mole of Zn(s) 2. 2Al(s)
Premium Chemistry Hydrogen Chemical reaction
Title: Measuring the loss in mass of Marble chips and Hydrochloric acid Aim: We will measure the loss in mass of the marble chips (CaCO 3 ) as it reacts with Hydrochloric acid (HCl). This one method of measuring the rate of reaction. We will use a balance to measure this mass loss as the reactants are used up to form product. Safety: * As Hydrochloric acid is corrosive wear a lab coat‚ gloves and safety goggles. * Take care when using the glassware not to cut yourself. * When
Premium Calcium carbonate Chlorine Hydrogen
Aim It is to tell how the reaction between magnesium and hydrochloric acid will be effected if we change the concentration of hydrochloric acid. Introduction In the experiment the magnesium reacts with the hydrochloric acid to create magnesium chloride and hydrogen. The balanced formula for this is: Mg(s) + 2HCL(aq) MgCl2(aq) + H2(g) Magnesium + hydrochloric acid Magnesium Chloride + Hydrogen Magnesium will react with hydrochloric acid‚ because it is higher in the reactivity series than hydrogen
Premium Chemical reaction Hydrogen Chlorine
Title : Expt.1 Determination of the enthalpy (heat) of reaction of a monobasic acid with sodium hydroxide Experiment no : 1 Experiment title : Determination of the enthalpy (heat) of reaction of a monobasic acid with sodium hydroxide Objectives: 1) To understand the enthalpy chemistry. 2) To determine the calorimeter constant. 3) To determine the enthalpy reaction of acid-base reactions. 4) To study the exothermic reaction. Apparatus and Materials : * Dewar flask
Premium Enthalpy Thermodynamics Energy
The aim for this investigation is to investigate the effects of varying the concentration of sodium thiosulfate solution on the rate of the reaction when reacting with dilute hydrochloric acid. It is hypothesized that as the concentration of the sodium thiosulfate solution increases‚ the rate of the reaction will also increase proportionately. Variables The independent variable is concentration. This will be varied by increments of 10mL (10mL to 50mL) and distilled water will be added accordingly
Premium Chemical reaction Chemistry Chlorine
Should fluorine be added to water? Introduction: Fluoride is a natural mineral and a chemical‚ which is a compound of fluorine that is the most commonly used in water sources. However not only for that‚ it also has a various number of other uses in example: making molten metals flow‚ and burning materials etc. as it is an extremely reactive and highly toxic element‚ so when it comes to adding fluoride to public water‚ that’s when mankind is faced with some extremely
Premium Drinking water Water purification Water
Introduction 1.1 Background Information Acids are separated into different categories. These categories are strong acids and weak acids. Hydrochloric and Sulphuric acid are strong acids‚ and Phosphoric acid is a weak acid. When an acid is placed into water‚ it ionises (Tinnesand‚ n.d.). Ionisation occurs when the acid splits up into its two base components. So when Hydrochloric acid is placed into water‚ it splits into a hydrogen ion and a chlorine ion. The amount that an acid ionises depends on its strength
Premium Acid Base Hydrogen
various metals by observing their reaction with hydrochloric acid. Materials: 2 M hydrochloric acid Detergent Test tubes and test tube rack 0.5 pieces of magnesium‚ aluminium‚ iron‚ zinc and cooper Sand paper Ruler Timer Bench mat Method: 1. The surface of the magnesium was cleaned with a piece of sandpaper 2. The Magnesium was placed into a test tube 3. Three Drops of detergent were added to the test tube 4. 2cm of hydrochloric acid was added to the test tube 5. The timer was set
Premium Metal Chemical element Periodic table
Diffusion of Hydrochloric Acid into Different Sizes of Agar Blocks Aim: Investigating the relationship between the diffusion and the surface area to volume ratio‚ with agar and hydrochloric acid. Research Question: How does the difference in surface area to volume ratio affect the diffusion? Hypothesis: As the area to volume ratio increases‚ the time taken for a complete diffusion will also increase. Background Information: Agar is a jelly like substance and in this experiment‚ agar
Premium Chlorine PH Hydrogen
PurposeIn this experiment‚ sodium hypochlorite (NaOCl) in acetic acid mixture was used to oxidize emdo-borneol (an alcohol) to camphor (a ketone). The product would then be purified by sublimation and then be analyzed by Infrared spectroscopy and melting point test. Procedure and ObservationsPlease refer to the lab manual and the carbon copy attached. Data and CalculationsWeight of endo-borneol = 0.2013gNo of moles of endo-borneol = 0.2013g/154.25g mol-1 = 1. 305mmolSince one mole of endo-borneol
Premium Chemistry Chlorine Sodium hydroxide