laboratory assignment 3 was to measure the rate at which a chemical reaction takes place. For the purpose of this lab we measured the rate a balanced oxidation/reduction reaction between iodine‚ hydrogen‚ and bromate ion occurs. The above reaction occurs slowly so we used a coupled iodine clock reaction to measure the rate of the oxidation/reduction reaction because it occurs much faster but is still dependent upon the other reaction. To accomplish this‚ two mixtures were prepared in separate Erlenmeyer
Premium Chemistry Chemical reaction Oxygen
Ocean County College Department of Chemistry Stoichiometry of a Precipitation Reaction Submitted by Hendy Zelishovsky Date Submitted: 4/26/2012 Date Performed: 4/25/2012 Lab Section: Chem-180-DL1 Course Instructor: Dr. Cynthia Spencer Purpose
Premium Stoichiometry Yield Water
Introduction The purpose of this experiment is to determine the rate equation for the “Iodine Clock Reaction” experiment. The experiment will consider the equations 〖2I〗^-+S_2 O_8→2〖〖SO〗_4〗^(2-)+I_2 and I_2+2〖S_2 O_3〗^(2-)→2I^-+S_4 O_6 in order to determine the rate law of Rate=k[〖〖S_2 O_8〗^(2-)]〗^a 〖[I^-]〗^b by using the experimental data to calculate the values of exponents a and b as well as the rate constant k. Experimental Supplies Needed: 250 mL Erlenmeyer flask‚ 100 mL beaker‚ graduated
Premium Chemical kinetics Rate equation Reaction rate
Abstract The experiment is to identify the guilty suspect that is present at the crime scene by comparing with the DNA samples. Polymerase Chain Reaction(PCR) is used to amplify the small amount of Deoxyribonucleic Acid (DNA) for forensic or genetic studies‚ which require necessary product and placed in the thermal cycle. Gel electrophoresis is being run in order to analyze and compare the DNA samples at the crime scene with the guilty suspects. Gel electrophoresis is used to separate DNA using
Premium DNA DNA Polymerase chain reaction
Lung Capacity I. Introduction. The chest contains two lungs‚ one lung on the right side of the chest‚ the other on the left side of the chest. Each lung is made up of sections called lobes. The lungs are soft and protected by the ribcage. The purpose of the lungs is to bring oxygen into the body and to remove carbon dioxide. Oxygen is a gas that provides us with energy‚ while carbon dioxide is a waste product or “exhaust” of the body. | To deliver oxygen to the body‚ air is breathed in through
Premium Lung Oxygen
The total protein content was estimated as proposed by Lowry et al. A bovine serum albumin stock solution (1mg/ml) was prepared in sodium hydroxide (1N). Five different concentrations (0.2‚ 0.4‚ 0.6‚ 0.8‚ 1 ml) of the prepared solution were taken in different test tubes. In another set of test tubes‚ 0.1 and 0.2 ml of the extract were taken. In each test tube‚ the volume was made up to 1 ml‚ followed by addition of the prepared alkaline solution (5 ml) at room temperature. The solutions were left
Premium Chemistry Protein Serum albumin
Mike Morrison – SCH3U Types of Chemical Reactions Lab Intro/Purpose The purpose of this lab is to determine types of reactions with only the reactants and through observation. Through observing the experiments‚ one is able to see a visual of each type of reaction taking place and it gives them a better understanding of how chemical reactions work and what products they may form. Materials & Procedure Materials: * Wood Splints - Copper Sulfate * Sodium Sulfate - Copper
Premium
IB Physics Internal Assesment – Design Aspect 1: Focused problem: Investigate the relationship between the surface area of a circular hole and the time water takes to drain through it. Variables: Independent: Surface area of the hole Dependent: Time water takes to drain Fixed: Amount of Water Container Environmental Conditions Aspect 2: Control of the Variables The independent variable in this case is the surface area of the hole‚ and the dependant will be the time water takes
Premium Bottle
BIOLOGY PLAN AND DESIGN LAB Date: / / Syllabus Topic: Hypothesis: A glass of milk lasts longer in cold temperatures. Aim: To determine a better range of temperature for storing a glass of milk. Apparatus and Materials: • 2-100cm3 beakers • 2-500cm3 beakers • Milk • Ice • Hot water • Marker Method: 1. Obtain 2 clean 100cm3 beakers and 2 clean 500cm3 beakers. 2. Add 50cm3 of milk to each 100cm3 beaker. 3. Label the 100cm3 beakers‚ A and B. 4. Label the 500cm3
Premium Temperature Scientific method Theory
purpose of this lab was to find the theoretical and experimental percentage yields of the double displacement reaction between the solutions Lead (II) Nitrate (PbNO3) and Potassium Iodide (KI). It is important to obtain amounts of Lead (II) Nitrate and Potassium Iodide as close to 1.44g as possible. This reaction creates Lead (II) Iodide and Potassium Nitrate. The precipitate during this reaction is Lead (II) Iodide. The balanced equation is Pb(NO3)2 + 2KI= PbI2 + 2KNO3. In this lab the Lead (II) Iodide
Premium Chemistry Chemical reaction Solubility