Experiment 3: Separation of the Components of a Mixture General Chemistry 101 (CHEM 101)‚ ISP SCUHS Report 2 September 15‚ 2013 Abstract Mixtures are made up of substances or components. If the mixture is fairly uniform in composition‚ properties‚ and its overall appearance‚ it is homogenous. If the component parts are clearly separated‚ it is heterogeneous. In order to identify the components in a mixture‚ methods must be used to sort out the components. However‚ the same methods will not
Premium Mixture Separation process Chemical substance
SEPARATION OF MIXTURE OBJECTIVE: To separate the components of a mixture based upon physical characteristics of each component within the mixture. Secondly‚ to determine the mass of each component by using the knowledge of separation techniques. SAFETY REQUIREMENTS: Do Not Pipette By Mouth Read the Chemical Safety Information Dress Appropriately Identify the Safety Equipment Don’t Taste or Sniff Chemicals Don’t Casually Dispose of Chemicals Down the Drain MATERIALS:
Premium Filter paper Mass Mixture
Experiment 3Quantitative Separation of Mixtures This experiment performs the quantitative separation of thecomponents of a mixture. A mixture is the mixing of two or more substancestogether. The proportions of the components in the mixture can be varied.And the resulting mixture can be either homogeneous or heterogeneous‚depending on the properties of components such as solubility.In this experiment‚ you are going to separate a water-solublecomponent from water-insoluble components
Premium Separation process Distillation Mixture
The Separation of Mixtures This lab demonstrates the difficult task of separating mixtures using different types of methods. This study is performed because it helps you understand the concept of separation and certain characteristics of elements. Previous knowledge in which already exists in this lab would be the process of filtration‚ distillation‚ magnetism‚ and evaporation. The specific hypotheses of this experiment was that the iron would separate through magnetism‚ the salt would separate
Premium Separation process Distillation Mixture
between the corrected number of moles and grams of urea and the amount of urea used originally used in the experiment‚ so the ammonium chloride will be primarily compared to the corrected amount of urea to make sure that the amount of solvent is equal. Graph 1 and 5 and Data Table 2 show that the mass of solutes were overall very similar: 8.735 grams of ammonium chloride and 8.99 grams of urea. Overall‚ this experiment proved that the freezing point depression is a colligative property that depends
Premium Chemistry Solution Solubility
Gorman and Tyler Kui) Lab #1: Separation of a Mixture Mr. Mejia 10/3/14 Separation of a Mixture Lab Report Abstract The purpose of the experiment was to separate an initial heterogeneous mixture composed of 5.00 grams of salt‚ 2.00 grams of sand‚ 50.0 mL of water‚ 15.00 grams of pebbles‚ and 1.00 gram of iron filings‚ and leave as much salt as possible remaining. Using separation techniques including magnetizing‚ evaporation‚ filtration‚ etc. the heterogeneous mixture was thoroughly separated into
Premium Laboratory equipment Separation process Water
DISTILLATION- SEPARATION OF A MIXTURE Ronald Ogbu‚ Alex 27th Aug. 2013 Purpose: To separate mixture of acetone and toluene using simple‚ packed and unpacked distillation columns. Results and Discussion: There were three distillation setups: simple‚ unpacked and pack fractional. All three procedures had different distillation apparatus but the unknown mixture was the same for all. The unknown liquid in a 50 ml round bottom flask was heated in a heating mantle such that a
Premium Distillation Separation process
9 2011 Lab report on separation of mixtures Purpose- The purpose of this lab is to separate or isolate the desired product from large amounts of solvent and by-products. It is also followed by a purification step that removes trace amounts of other substances from the final product. One of the experimental techniques that we used in the lab to separate or purify mixture is fractional crystallization. In the experiment we used fractional crystallization to resolve a mixture of salicylic acid and
Premium Chemistry Water Separation process
Title: Lab #3 Separation of a Mixture of Solids Purpose: To understand the different separation methods and techniques that depend on the chemical properties of a specific substance. Also to become more comfortable with performing those actions of separation so I have them in the future. For this experiment‚ I will separate a mixture of four distinct substances: sodium chloride‚ benzoic acid‚ silicon dioxide‚ and iron fillings into pure beings. Procedure: Materials: distilled water coffee
Premium Water Mass Weight
Separation of Iron‚ Salt and Sand Separating a mixture is an example of a physical change. There are several ways to separate a mixture. The use of one’s hands in pulling the parts of a mixture apart is one example. Filtration is another way to separate mixtures. Filtration is the separation of a heterogeneous (not alike‚ different) mixtures‚ by adding a solvent and passing the resulting mixture through a fine mesh or filter. Evaporation of a homogeneous (alike‚ same) mixture will reveal
Free Mixture Separation process Water