FEASIBILITY STUDY FOR COMPUTERIZED AUTOMATION OF EPA REGIOTCfl TECHNICAL SUPPORT BRANCH ^Fred B. Stephens‚’William F. Morris‚ 7 George W. Barton‚ Jr.‚ and Eugene R. Fisher February 9‚ 1978 Work performed under ths auspices of the U.S. Department of Energy by the UCLLL under contract number W-7Jo5-ENG-48. INHLAWREISiCE I U 5 UVERMORE I S LABORATORY ^^OPTal-DOCDMSOT-B «nica3Sl> Distribution Category UC-11 LAWRENCE LIVERMORE LABORATORY University of CakfaTiia/Livetmore‚ CaHfomie^/94550
Premium Computer Analytical chemistry Laboratory equipment
Title: Competing Nucleophiles (Exp 24‚ pp 211-221‚ pp 808-823‚ pp 836-842) Purpose: The purpose of this experiment is to determine the nucleophilic strength of chloride and bromide ions as it reacts with 1-butanol (n-butyl) and 2-methyl-2-propanol (t-butyl alcohol) under SN1 and SN2 conditions. Method: 40 g of ice and approximately 30 ml of sulfuric acid is cautiously added to a 100 mL beaker respectively. Weigh 7.6 g of ammonium chloride and 14.0 g of ammonium bromide and place it in
Premium Nuclear magnetic resonance Nucleophile Chromatography
The goal of this experiment was to measure spectroscope position to calculate wavelengths of line emission spectra while also using this data to determine the unknown mixture of the flame emission procedure of the experiment. The original hypothesis was that the spectroscope would show multiple different line emission spectra in which the ΔE would be negative there was an emission of light as the electron’s decreased in electron transitions. This hypothesis was proven correct‚ as well as‚ the unknown
Premium Chemistry Light Spectroscopy
In experiment 3.1.We set up and calibrate the spectronic 20 first since it takes time to be ready to use so‚ we turned the spectronic 20 to warm up for at least 15 minutes‚ set wavelength to 360 while no test tube in it. Also‚ we set the filter lever in order to match the wavelength range‚ and then set the transmittance to 0%‚ then we changed the mode to absorbance. After we labeled two test tubes which were #5 and #10‚ we inserted water first to set 0 absorbance‚ then we used #5 sample to read it
Premium Test method Spectroscopy Chemistry
Quartz-type FePO4 was investigated from 294 up to 1073K by neutron powder diffraction. The cell parameters and fractional atomic coordinates in the α phase tend towards the values found in the β phase. The first order transition of FePO4 is at 980 K‚ during which several observations are made. Firstly‚ the cell parameters and fractional atomic coordinates show discontinuous shifts. Secondly‚ the intensities of a large number of diffraction lines decrease‚ as shown in Fig. 1. Lastly‚ bond distances
Premium Chemistry Atom Chemical element
SPECTROPHOTOMETER INTRODUCTION In chemistry‚ spectrophotometry is the quantitative measurement of the reflection or transmission properties of a material as a function of wavelength. It is more specific than the general term electromagnetic spectroscopy in that spectrophotometry deals with visible light‚ near-ultraviolet‚ and near-infrared‚ but does not cover time-resolved spectroscopic techniques. Spectrophotometry involves the use of a spectrophotometer. A spectrophotometer is a photometer
Premium Spectroscopy Chemistry Light
NATIONAL UNIVERSITY OF RWANDA FACULTY OF APPLIED SCIENCES DEPARTMENT OF COMPUTER SCIENCE BACC IV ACADEMIC YEAR: 2012-2013 CHAPTER 1. TOPIC: DESIGN AND IMPLEMENTATION OF AN ONLINE COMPUTER LABS MONITORING SYSTEM CASE STUDY: NATIONAL UNIVERSITY OF RWANDA ICT CENTER/Helpdesk Unit
Premium Laboratory Software engineering Computer
Abstract Chemically active extraction was used to separate two unknown compounds from each other and to determine what compound class each compound belongs. The solid unknown was purified by recrystallization and its melting point range was determined to be 109-111°C. The liquid unknown was purified by simple distillation and its boiling point was determined to be 95°C. An IR spectrum was collected for each of the purified compounds; the solid was determined to be 3-toluic acid and the liquid was
Premium Nuclear magnetic resonance
Tiboelectric Series Lab Fleur Vande Kerckhove 9A Purpose/Aim: How do the triboelectric series from different materials classify themselves due to their affinity (gaining or losing) when being measured by a gold leaf electroscope? Hypothesis: If the materials change (from: wool‚ rabbit fur‚ cotton‚ aluminum‚ nylon‚ amber‚ celluloid‚ silver‚ silicon and acrylic) to classify their affinity of their triboelectric series then rabbit fur will have a higher affinity compared to the rest of the materials
Premium Oxygen Light Ultraviolet
Infrared Spectroscopy Aim: To obtain IR spectra of know solid sample and liquid sample using the following sample preparing technique: Prepare solid IR sample using Solid Pellet Samplin Technique Use IR is used to identify functional groups. 5 major functional groups easily identified by IR spectroscopy: 1. C=O 2. C–O 3. OH 4. Phenols 5. C–H Instrument details Type of spectrophotometer: Nicolet 380 FT-IR spectroscopy‚ Nicolet Avatar 360 & Thermo Scientific iS10 FT-IR Spectrometer
Premium Infrared spectroscopy Infrared Spectroscopy