06.03 Calorimetry: Lab Report Before You Begin: You may either copy and paste this document into a word processing program of your choice or print this page. Instructions: This is a two-part lab. Be sure to follow all steps given in the lab and complete all sections of the lab report before submitting to your instructor. Procedure: Part I: Determining the Specific Heat of a Known Metal 1. Place a plastic measuring trough on top of the digital balance‚ and press the "tare/on" button so that
Premium
Determining the Enthalpy of Combustion of a Wood Chip IB Chemistry 12 September 18‚ 2014 Ryan Ingham Table 1: Raw data collected from the temperature probe and scale for the water‚ the aluminum can and the wood chip. (Quantitative) Quantity Initial Temperature (±0.1K) Final Temperature (±0.1K) Aluminum Can 46.29g (±0.01g) 296.5 314.7 Water 250g (±0.1g) 296.5 314.7 Wood Chip Before: 4.64g(±0.01g) After: 3.29g (±0.01g) NA
Premium Soot Energy Enthalpy
(Ti) of the water. Note that the initial temperature and the final temperature will be used to get the “change of temperature” of the water. Take out the metal from the oven and quickly put it in the beaker with water while simultaneously taking its temperature using the temperature probe. In this process‚ heat transfer is taking place. While the computer is recording the measurement‚ changes in the temperature is evident. The water temperature goes up from its initial room temperature to a higher
Premium Heat Temperature Thermodynamics
N12/4/CHEMI/SPM/ENG/TZ0/XX 88126104 CHEMISTRY standard level Paper 1 Friday 9 November 2012 (afternoon) 45 minutes INSTRUCTIONS TO CANDIDATES • Do not open this examination paper until instructed to do so. • Answer all the questions. • For each question‚ choose the answer you consider to be the best and indicate your choice on the answer sheet provided. • The periodic table is provided for reference on page 2 of this examination paper. • The maximum mark for this examination
Premium Zinc Atom Periodic table
Chemistry Changes Everything: ¹ᶟ¹I - Iodine¹ᶟ¹ An isotope is two or more forms of an element where the nuclei of the element has more neutrons than protons and normally each element only has one stable isotope of the element. Changing the neutrons in the atom also changes the atomic mass but not chemical properties. Radioisotopes are radioactive versions of an isotope where the atom or element has an unstable nuclei therefore emitting radiation. An unstable nuclei is created when there is either
Premium Nuclear fission Neutron Uranium
Thermochemistry: An Ice Calorimeter Determination of Reaction Enthalpy D. F. Nachman 6/23/2010 Abstract: An ice calorimeter was used to study the reaction of magnesium metal and 1.00M sulfuric acid solution: Mg(s) + H2SO4(aq) →MgSO4(aq) + H2(g). We found the experimental molar enthalpy of reaction to be ΔH = –355 ± 17 kJ/mol at 0°C‚ 24% lower than the textbook value of ΔH° = –466.9 kJ/mol‚ reported at 25°C. Introduction Whether a chemical reaction occurs spontaneously or is driven by an outside
Premium Energy Enthalpy Thermodynamics
sulfuric acid in solution. The = for the reaction of sulfuric acid and magnesium metal. Introduction This report demonstrates calorimetry‚ or the technique of measuring heat effects in the surroundings. In order to make sure that there is no temperature change‚ or that it is an isothermal heat transfer‚ it is kept at a similar temperature in an ice bath. By knowing the change in volume‚ the density of ice‚ and the density of liquid water‚ it is presumed that then you could decipher the mass of the
Premium Thermodynamics Energy Heat
CH 222 ANALYTICAL CHEMISTRY I SYLLABUS COURSE OUTLINE: a. Introduction (1.5 hours) Classification of types of analysis‚ role and importance of analytical chemistry in various aspects of life. b. Steps in a typical quantitative analysis (10 hours) Emphasis on sampling protocol‚ sample preparation‚ wet chemistry methods‚ statistical evaluation of data. c. Review of concepts of stoichiometry (2 hours) Mole concept‚ concentrations‚ dilution and aliquots d. Review of concepts of equilibria
Premium Chemistry
Chapter 1: Intermolecular Forces: Liquids‚ Solids‚ and Phase Changes Chem 11: General Chemistry 2 Topics 1.1 An Overview of Physical States and Phase Changes 1.2 Quantitative Aspects of Phase Changes 1.3 Types of Intermolecular Forces 1.4 Properties of the Liquid State 1.5 Uniqueness of Water 1.6 The Solid State: Structure‚ Properties and Bonding A hot spring on a snowy day The Kinetic Molecular View of the Three States The characteristic properties of gases‚ liquids
Premium Water Atom Fundamental physics concepts
06.03 Calorimetry: Lab Report Before You Begin: You may either copy and paste this document into a word processing program of your choice or print this page. Part I The Dissolving of Solid Sodium Hydroxide in Water Procedure: 1. Measure out approximately 200 mL of distilled water and pour it into the calorimeter. Stir carefully with a thermometer until a constant temperature is reached. Record the volume of water and the constant initial temperature of the water on your data table.
Premium