oxygen in the water. If acid isn’t added the solution will quickly start to turn yellow due to formation of MnO2. If this happens anyway‚ add some more sulphuric acid to reverse the process. The solution should be clear with a slight green tinge. Chapter 15 – Volumetric analysis (Redox titrations) To prepare a standard solution of ammonium iron sulphate and use this solution to standardise a solution of potassium permanganate. Potassium permanganate (KMnO 4 ) is a powerful oxidizing agent and is
Free Titration
of Chemical Engineering CHME 426 –Chemical Engineering Laboratory III Title Page (Full Report) Title of the Experiment: Reaction through three CSTR in series Submitted by: Group (4) Section: Female 1. Name: Amina Ali ID: 200550284 2. Name: Duaa Tabarak ID: 200553858 3. Name: Mariam Rustom ID: 200552242 Date of experiment: 31st March‚ 2010 Date of submission: 11th April‚ 2010 Grades: Report presentation………………………………………… /15 Abstract and Objective(s)……………………………………/10 Introduction
Premium Sodium hydroxide Chemical reaction
| FLAME PHOTOMETER | | MT-124 | Microprocessor Flame Photometer | 43900 | MT-125 | Digital Flame Photometer Double Display | 27980 | MT-126 | Digital Flame Photometer Single Display | 23800 | ACS | Air Compressor | 5500 | ACS | Filter-Sodium/Potassium/lithium/calcium | 3100 | | SPECTROPHOTO METER | | MT-127 | Digital Spectrophotometer Double Display (10 mm) | 26800 | MT-128 |
Premium Electrochemistry PH
The effect of time on enzyme reaction. Abstract: In this lab investigation we will observe how the amount of hydrogen peroxide is affected by catalase over time. The enzyme was added to 10 mL’s of hydrogen peroxide and observed over time to determine the relation between time and enzyme activity. The hypothesis stated that as time increased substrate would decrease. Therefore I predicted that at 60 seconds‚ there would be the least amount of H2O2. The enzyme activity mirrored my predictions
Premium Oxygen Enzyme Hydrogen peroxide
The rate of reaction between sodium thiosulphate and hydrochloric acid Candidate name: Yeo Jin Kim (Kimberly Kim) Candidate number: 000791-021 Teacher: Yitao Duan 1.0 Aim The aim of this experiment is to investigate the changing of concentration effect the rate of reaction between sodium thiosulphate and hydrochloride. 2.1 Chemical Equation 2.0 Raw data 3.2 Qualitative Data 2.1.1 Before the experiment Substance | Color | State | Smell | Hydrochloride (HCl) | Colorless
Premium Chemical reaction Sodium Chemistry
Chem 102 - Lab #2 Quantitative Analysis of a Soluble Sulfate Steven English Lab Instructor: Dr. Campo Date: Tuesday‚ February 5th 2013 Pre-Lab Questions A. Adding the acid to the sodium sulfate solution results in an increase in the solubility of any free anions present in the sample. This will happen because the present anions will bind with the hydrogen cations present in the acid. B. The sodium sulfate is boiled because experiments have shown that barium sulfate is 50
Premium Solubility Chemistry Ion
Title : Expt.1 Determination of the enthalpy (heat) of reaction of a monobasic acid with sodium hydroxide Experiment no : 1 Experiment title : Determination of the enthalpy (heat) of reaction of a monobasic acid with sodium hydroxide Objectives: 1) To understand the enthalpy chemistry. 2) To determine the calorimeter constant. 3) To determine the enthalpy reaction of acid-base reactions. 4) To study the exothermic reaction. Apparatus and Materials : * Dewar flask‚ stopwatch
Premium Enthalpy Thermodynamics Energy
5.05 Mixtures and solutions Lab report Ink Chromatography Chromatography is also used to compare and describe chemical substances. The chromatographic sequence of sorbed substances is related to their atomic and molecular structures. A change in a chemical substance produced by a chemical or biological reaction often alters the solubility and migration rate. With this knowledge‚ alterations or changes can be detected in the substance. Chromatography serves mainly as a tool for the examination and
Premium Mixture Chemical substance Molecule
Lab 12: Reduction of an Aldehyde to a Primary Alcohol by Use of NaBH4Purpose(i)To select an appropriate solvent system. (ii)To synthesize alcohol from aldehyde by NaBH4 reduction. (iii)To identify the aldehyde isomer based on the melting point of the alcohol produced. Procedure(Please refer to the detailed instructions on lab 12 handout)Physical Quantity TableType of substanceMolecular FormulaMolecular Weight (g/mol)Density(g/cm3)Melting Point(oC)Boiling Point(oC)HazardO-vanillinC8H8O3152.15-42
Premium Solvent Chemistry Alcohol
Title: Stoichiometry Reaction Objectives: 1. To decompose sodium hydrogen carbonate (sodium bicarbonate) by heating. 2. To accurately measure the degree of completion of the reaction by analysing the solid sodium carbonate product. 3. To calculate amount of product with given amount of reactant. 4. To determine amount of heat release in the reaction. Results: Part 1: Thermal Decomposition of NaHCO3 Materials Mass (g) Clean and dry test tube 15.1632 Clean test tube + NaHCO3 17.1647
Premium Chemical reaction Chemistry Chlorine