"Concentration" Essays and Research Papers

Sort By:
Satisfactory Essays
Good Essays
Better Essays
Powerful Essays
Best Essays
Page 34 of 50 - About 500 Essays
  • Good Essays

    Osmosis in Potatoes

    • 1324 Words
    • 6 Pages

    How is Osmosis Affected By the Concentration PLANNING Independent Variable The independent variable in this experiment is the thing that I will be changing in the experiment. This is the range of concentrations that have been obtained by diluting the original 1M solution of Sucrose. This is therefore the only thing that is going to be altered as I am investigating how different percentage of water molecules affects the weight of the the potato thus the rate and direction of osmosis.

    Premium Concentration Chemistry Water

    • 1324 Words
    • 6 Pages
    Good Essays
  • Good Essays

    Equal volumes of 7mM ABTS and 35mM K2S2O8 (potassium per sulphate) were mixed and incubate for 24 hours. 1200 μl of the sample‚ from each concentration i.e. 50- 500 μg/ml‚( each of these concentration was taken in duplicate) was mixed with 1800 μl of ABTS solution was mixed with it for each concentration. Similar process was repeated for ascorbic acid concentration. All test tubes (ethyl acetate soluble fraction‚ ethyl-3-hydroxy-5-methoxy-4-methylbenzoate‚ ascorbic acid‚) labeled separately were shaken

    Premium Ethanol Solvent Ascorbic acid

    • 1034 Words
    • 5 Pages
    Good Essays
  • Good Essays

    potatoes chips in solutions. The solution was different concentration of salt and water‚ one was 5% sugar‚ one 10%‚ one 15%‚ one 20% and one 30% salt concentration. We measured the mass of the potatoes chip before and after we put it into the solution. To keep the experiment fair we only changed one variable which was the salt concentration. The results that we got showed the chip went up in mass for 0% salt concentration and 5% salt concentration but for 10%‚ 15%‚ 20% and 30% it went down in mass

    Premium Concentration Potato Potato chip

    • 525 Words
    • 3 Pages
    Good Essays
  • Better Essays

    Processes and Active Processes Introduction In this lab we will establish a difference between the two types of cell transport mechanisms and their permeability. The first type of cell transport is passive processes which are driven by concentration or pressure differences in the interior and exterior of the cell. The second type is active processes which use energy known as ATP to power the transport. There are two main types of passive processes called diffusion and filtration. This can

    Premium Diffusion Molecular diffusion Osmosis

    • 1906 Words
    • 8 Pages
    Better Essays
  • Satisfactory Essays

    LAB 20C

    • 561 Words
    • 3 Pages

    Liangting Lin 1-4 Lab Partner: Sunny Zhao 20C: Acid-Base Titration Purpose/Objective: 1. To titrate a hydrochloric acid solution of unknown concentration with 0.50M sodium hydroxide‚ and determine the molarity of the hydrochloric acid 2. To titrate an acetic acid solution with 0.50M sodium hydroxide‚ and determine the molarity and percentage composition of the vinegar. Apparatus and Materials:

    Premium Chlorine Acetic acid Sodium chloride

    • 561 Words
    • 3 Pages
    Satisfactory Essays
  • Good Essays

    the tubes contained different amount of sucrose concentrations. The higher molarity concentrations increased the movement of water to balance out the inside of the tube and the beaker. The greater amount of concentration gradient‚ in each tube‚ increased the rate of osmosis. This rate of osmosis is due to the net movement of water from an area of low concentration to an area of high concentration. Because the tubes had different concentrations‚ certain tubes gained more mass than others. Solution

    Premium Chemistry Osmosis Solution

    • 275 Words
    • 2 Pages
    Good Essays
  • Good Essays

    Daphnia heart rate Independent: caffeine concentration Dependent: heart rate of Daphnia Measuring the content of Vitamin C in fruit juice Independent: fruit juice Dependent: volume of juice required to decolourise 1cm3 of DCPIP The effect of temperature on cell membranes Independent: temperature of water Dependent: % transmission of light through resulting solution The effect of changing enzyme concentration on rate of reaction. Independent: concentration of enzyme dependent: time taken for enzyme

    Premium Petri dish Laboratory glassware Agar plate

    • 2043 Words
    • 12 Pages
    Good Essays
  • Better Essays

    calorimeter is used to measure the heat of solution of KNO3 in water. The generalized reaction for this solvation is: A + x S → A xS (solution at m concentration) Where: A is pure solute S is pure solvent which is mixed to form a solution m is the molal concentration. . The change in enthalpy accompanying this reaction depends upon the final solution concentration. Two measures of enthalpy have proved useful in determining the heat of solution: the integral heat of solution and the differential heat of

    Premium Thermodynamics Enthalpy Concentration

    • 1882 Words
    • 8 Pages
    Better Essays
  • Satisfactory Essays

    Laboratory Exercise #2 Pre Lab This lab will teach me how to use a spectrophotometer. The use of the spectrophotometer is to measure the concentration of solute. The solute being measured must be colored and is determined based on the adsorption of light photons on a wavelength. The spectrophotometer uses a beam of light that strikes the diffraction grating that basically forms of prism of light. Then only a specific wavelength of light shines through the spectrophotometer and interacts with

    Free Light Optics Electromagnetic radiation

    • 1420 Words
    • 6 Pages
    Satisfactory Essays
  • Good Essays

    solidification

    • 1293 Words
    • 6 Pages

    ELECTRODEPOSITED NI-BASED NANOCOMPOSITES ELECTRODEPOSITION • Electroplating is often also called "electrodeposition“. • It’s a process using electrical current to reduce cations of a desired material from a solution and coat that material as a thin film onto a conductive substrate surface. • The overall process is also known as electrolysis. OBJECTIVE • To apply thin films of material to the surface of an object to change its external properties such as to increase corrosion protection

    Premium Electric current Corrosion Metal

    • 1293 Words
    • 6 Pages
    Good Essays
Page 1 31 32 33 34 35 36 37 38 50